Connection/Installation

Connection

Connect to AC 220 V-

D/N AUTO

ON

SEE INSTRUCTION

 

MANUAL

BLC OFF

ON

 

LCD

CRT

VIDEO

AES OFF

ON

OUT

MONITOR TYPE

 

 

 

 

FOCUS

 

 

ADJUST

CLASS 2 ONLY

 

 

(U TYPE)

 

 

ISOLATED POWER

 

SET

ONLY (E TYPE)

AUX GND

 

To the terminal of infrared illumination device etc.

(TK-C9300U/TK-C9300E/ TK-C9301EG) (A page 8)

Monitor

(A page 8)

AC 240 V power supply (TK-C9201EG/

TK-C9301EG) (A page 8)

MENU

DC12V

12 AC24V

Connect to AC 24V or DC 12V power supply (TK-C9200U/

TK-C9200E/TK-C9300U/TK-C9300E) (A page 7)

Connecting the Power Supply Cable

When power is supplied to the camera, the [POWER] lamp on the side panel lights up.

mAC24 V or DC12 V (TK-C9200U/TK-C9200E/TK-C9300U/TK-C9300E)

To prevent connection errors or a cable disconnection, use a lug plate to connect to the terminal. The following table shows the connection distances when 2-core VVF (vinyl-insulated vinyl sheath cables) are used. (Reference value)

Conductor diameter (mm)

Φ 1.0 and

Φ 1.6 and

Φ 2.0 and

 

more

more

more

 

 

 

 

Maximum connection

50 m

140 m

220 m

distance: DC 12 V

 

 

 

 

 

 

 

Maximum connection

130 m

350 m

550 m

distance: AC 24 V

 

 

 

 

 

 

 

Memo v If thin cables are used, the resistance of the cables will be high and a significant voltage drop will occur when the camera is at its maximum power consumption. Either use a thick cable with low resistance or place the power supply near to the camera and shorten the length of the cable to restrict the voltage drop at the rated current of camera to below 10 %. If voltage drop occurs during operation, the performance will be unstable.

vDo not connect an AC 24 V cable to a commercial power supply. If it is connected by mistake, the internal circuit may be damaged. Sent the camera to the nearest JVC service center for inspection as the internal circuit may be damaged.

7