JVC LVT1305-004A manual Operations,
 !#$%, To turn on the power, To cut of the power,
 !Power

ENGLISH

Operations

Front /=￿￿

Power lamp

 !"

￿￿

￿￿

Rear /=￿￿

Turning On the Power—POWER

To turn on the power.

Press the POWER switch to the ON position.

• The power lamp lights in green.

To cut of the power.

Press the POWER switch to the OFF position.

•The power lamp goes out.

•This will disconnect the mains lead.

Operating the Unit Automatically According to the Incoming Signals—AUTO POWER ON/STANDBY

To activate AUTO POWER ON/STANDBY.

Press the AUTO POWER ON/STANDBY switch to the [ ] ON position.

•If no sound comes in for 5-10 minutes, the unit enters standby mode. The power lamp lights in red.

•If the unit detects incoming signals, the unit starts operating. The power lamp lights in green.

To cancel AUTO POWER ON/STANDBY.

Press out the AUTO POWER ON/STANDBY switch to set it to the [_] CANCEL position.

AUTO POWER ON / STANDBY

CANCEL ON

When the volume level of the amplifier is so low or the incoming signals are so weak that this unit cannot detect sounds, Auto Power On/Standby may not work correctly.

 !"POWER

 !"

￿POWER ON￿￿￿

•
 !"#$%&"'

 !"

￿POWER OFF

•
 !"#$%&

•
 !"#$%

 !"#$%&'()*

AUTO POWER ON/STANDBY

￿￿AUTO POWER ON/STANDBY
￿AUTO POWER ON/STANDBY	[ ] ON

•￿5￿10
 !"#$%&'()*+,-./012,345
 !"#$%&"'

•
 !"#$%&'( )*+,-./0123)456

￿￿

￿￿AUTO POWER ON/STANDBY
￿AUTO POWER ON/STANDBY	=[_] CANCEL

AUTO POWER ON / STANDBY

CANCEL ON

備忘錄

 !"#!$%&'()*+,-'./0123456!7,-

￿￿AUTO POWER ON/STANDBY
 !"#L
 !"#"$%
 !"

– 5 –