10

Tuning in to a Station

1

Press TUNER/BAND to select either

“FM” or “AM.”

The unit automatically turns on and tunes in to
the previously received station—either FM or
AM (MW).
•Each time you press the button, the band alternates
between FM and AM (MW).
2

Press and hold ¢ or 4

(or ¡/¢ or 4/1 on

the unit) for more than 1

second.

•¢ (¡/¢):
Increases the frequencies.
•4 (4/1):
Decreases the frequencies.
The unit starts searching for stations and stops when a
station of sufficient signal strength is tuned in.
•If an FM program is broadcast in stereo, the ST (stereo)
indicator lights up on the display (only when the
reception is good).
To stop during searching, press ¢ or 4 (or ¡/¢ or
4/1 on the unit).
When you repeatedly press ¢ or 4 (or ¡/¢ or
4/1 on the unit)
The frequency changes step by step.
Listening to FM and AM (MW) Broadcasts
TUNER/
BAND
To change the FM reception mode
On the remote control ONLY:
When an FM stereo broadcast is hard to receive
or noisy, press FM MODE so that “MONO”
appears and the MONO indicator lights up on the
display. Reception will improve.
To restore the stereo effect, press FM MODE again so that
“STEREO” appears and the MONO indicator goes off. In
stereo mode, you can hear stereo sound when a stereo
program is broadcast.
To reduce the beat when listening to an AM (MW)
station—Beat Cut
On the remote control ONLY:
While recording an AM (MW) broadcast, beats
may be heard (which are never heard when
listening to the broadcast without recording it).
If this occurs, press BEAT CUT repeatedly, while
recording, until the beats are reduced.
•Each time you press the button, the display alternates
between “CUT–1” and “CUT–2.”
FM MODE
BEAT CUT
Continued
UX-G1[B]_rev_06tuner_f.p65 05.1.28, 11:28 AM10