JVC LYT0261-001B manual Tape Remaining Time, Displayed and the tape remaining time warning

INDEX Indications						EN69
	1	2 3	4	5		6
	30MIN		FINE 12	T30
7	REC SP				%
8	2	FADER		01	^
		LENS COVER			&
9					*	1X
0	15S	PAUSE			(
!		TAPE END			)	a
	5S				q
@	BRIGHT
#	MERRY CHRISTMAS					b
$	DEC 25. 99		AM 11 :	45 : 18

1 Cassette Warning/		☞ pg. 19
Tape Remaining Time
When no cassette is inserted: the cassette (			)
warning blinks.
When the Erase Protection tab is not in the position
that allows recording: the cassette (		) warning
lights. Otherwise, the tape remaining time is
displayed and the tape remaining time warning
blinks when the tape is about to reach its end.
When the Power Switch is set to “PLAY” and a
tape is loaded: the cassette (	) mark is displayed
regardless of the Erase Protection tab’s position.
2 Recording Mode (SP/EP) Indicator		☞ pg. 14
3, 8 Program AE Indicator		☞ pg. 32

Displayed at 3 for approx. 2 seconds when Program AE with special effects is switched from one mode to another by pressing P.AE., then only the indicator remains at 8.

3, 9 Fade/Wipe-Standby Indicator .......... ☞ pg. 31

Displayed at 3 for approx. 2 seconds when the Fade/Wipe is switched from one effect to another by pressing EFFECT, then only the indicator remains at 9.

4 •Picture Mode Display	☞ pg. 23, 24
•Remaining Number Of Shots	☞ pg. 23, 24
Indicator
5 Tape Length Indicator	☞ pg. 14
6 Zoom Indicator Bar	☞ pg. 28
Zoom Level Indicator
Approximate Zoom Ratio
7 Recording Indicator	☞ pg. 18
0 Picture Stabilizer Indicator	☞ pg. 29

!Interval Timer/Recording Time

Indicator	☞ pg. 44, 61
@ •Bright Level Indicator	☞ pg. 47
•Speaker Volume Indicator	☞ pg. 47
# Instant Title Display	☞ pg. 35
$ Date/Time Display	☞ pg. 34

%Battery Pack Remaining Power Indicator Changes as follows according to the battery pack’s remaining power level:

“ ”. When the power is

almost gone, the indicator “ ” blinks (battery power warning), then the unit shuts off. Replace the battery pack with a fully charged one.

Note: The symbol containing 3 darkened squares —

— does not necessarily mean that the battery pack is fully charged.

^ Focus Indicator	☞ pg. 40
& Exposure Control Level Counter	☞ pg. 39
* White Balance Mode Indicator	☞ pg. 42
( •Record–Standby Mode Indicator	☞ pg. 18
•Lens Cover Warning:	☞ pg. 19
LENS COVER

)Clock Battery Warning

Blinks for approx. 10 seconds when the power is turned on. This display also blinks when the clock (lithium) battery is either not installed or has

discharged. Install or replace the old battery with a new one (☞ pg. 12).

q • Tape End Display: TAPE END ............ ☞ pg. 19

Appears when the end of the tape is reached during playback, recording or fast-forward.

•Condensation Warning:

When this indication appears, all functions except tape eject and power on/off are disabled. Turn the unit off (without removing the power source) for a few hours, and when you turn it on again the indication should disappear.

•Head Clog Warning:

Appears if dirty heads are detected during recording. In such a case, use the optional Cleaning Cassette. If, after using it, the problems still exist, consult your nearest JVC dealer.