6 Start playback using control buttons.

Control buttons

●You can view playback on the camcorder’s LCD monitor.

Start button

7Check playback on the camcorder’s LCD monitor, and then click [Start] approximately 2 seconds before the scene from where importing to be started.

8Check playback on the camcorder’s LCD monitor, and then click [Cancel] after the scene to be imported finishes.

9Click the close button on the upper right of the window to quit HD Capture Utility.

10Disconnect the i.LINK cable.11Set the camcorder’s Power Switch to ”OFF”.

The camcorder turns off.

NOTES:

●It is not possible to import a scene less than 5 seconds.

●The continuous scene may be divided into two or more files depending on the environment of you PC or condition of the tape.

●It is not possible to import video stream from other devices such as a D-VHS VCR.

●The HD Capture Utility is compatible only with MPEG-format video stream. To import DV-format video stream, use commercially available video edit software which is compatible with DV format.

●It is recommended to import video stream a little longer (including parts before and after the necessary part) than that you actually need. Unnecessary parts of the video clip can be deleted (cut) by MPEG Edit StudioTM Pro LE.

●If there are blank or drop-out parts, or switching point of recording mode between 480p and 720p, the video stream will be automatically divided into two or more files. The numbers are added to the file, for example ”Cap0001.m2t”, ”Cap0001(0001).m2t”, and ”Cap0001(0002).m2t”.

— 15 —

CONTINUED ON NEXT PAGE