JVC MC-D207U How to Open the Drive Storage Cover, How to Install the DVD-ROM Drive

INSTALLATION

2. How to Open the Drive Storage Cover			• Figure shows the MC-2200U		Drive No.6
					Drive No.5
	Please also refer to the corresponding sections in the		or MC-8200U
					Drive No.4
	Library instructions.			Drive storage	Drive No.3
1. Remove the screws from the drive section cover,				section
					Drive No.2
	which is located at the rear of the Library.				Drive No.1
2.	Remove the drive storage cover.				Drive storage cover
					Screws
	Drive storage				• Figure shows the MC-2100U
					or MC-8100U
	section				Drive storage
	Drive No.6				section
		Drive storage
	Drive No.5
		section
	Drive No.4	Drive storage		Screws
	Drive No.3
		cover
	Drive No.2
	Drive No.1	Screws
		To be reused when
		refitting the cover later.		Drive storage
	• Figure shows the MC-1200U/E
				cover

Drive No.4

Drive No.3

Drive No.2

Drive No.1

Screws

3.How to Determine the Installation Position of the DVD-ROM Drive

1.Install drive from the No.1 to No.6 slot in that order without skipping.

Starting installation from the lowest No.1 slot will simplify future installation work.

4.How to Install the DVD-ROM Drive

1.Insert the drive from the rear of the JVC CD-ROM or CD/DVD Library.

Pay attention not to damage the sensor slit.

Always insert the DVD-ROM Drive correctly.

Check that cables connected on the rear of the unit are not caught or pinched when inserting the DVD-ROM Drive.

2.Insert the DVD-ROM Drive slowly until the screw installation hole located on the side of the DVD-ROM Drive and the screw installation hole located on the drive locking section are aligned.

3.Lock the DVD-ROM Drive in place by using the drive locking screw on the door panel side of the drive.

Tighten the screw firmly.

If the drive locking screw is loose, the drive and/or CD-ROM, CD/ DVD Library could suffer damage.

Drive storage section

Sensor slit

•Beware of damage

Drive locking section

Drive locking screw

4