JVC MC-D207U How To Refit The Drive Storage Cover, Automatic Drive Detection Mode

INSTALLATION

2. ID2 - ID0 : This sets the SCSI ID No. on the drives.

SCSI ID		Switch		Remarks
No.	ID2	ID1	ID0
0	OFF	OFF	OFF
1	OFF	OFF	ON	Default factory setting
2	OFF	ON	OFF
3	OFF	ON	ON
4	ON	OFF	OFF
5	ON	OFF	ON
6	ON	ON	OFF
7	ON	ON	ON

Set the SCSI ID No. between 0 - 7 using only an ID No. that is not being used by other SCSI devices.

For the details on default factory settings, please refer to the section “SCSI ID No. SETTING” of the instructions for the JVC CD-ROM or CD/DVD Library.

3.Set the slide switch.

Be sure to set the slide switch to N for use. (The position W is provided for service use only.)

7.How To Refit The Drive Storage Cover

Always refit the drive storage cover before switching ON the JVC CD-ROM or CD/DVD Library.

1. Fasten the cover with the screws that were removed in the procedure ( 2 -1).

8.How To Close And Lock The Door Of The JVC CD-ROM or CD/DVD Library

Always close and lock the door before switching ON the JVC CD-ROM or CD/DVD Library.

1.Close the door and lock the key cylinder.

2.Turn the power switch ON.

Before you add, remove or replace drives, and/or change the SCSI ID No., turn OFF the power of the host computer. Remember to turn it ON again after completing the necessary operations.

9.Automatic Drive Detection Mode

Please also refer to the corresponding sections in the CD/DVD Library instructions.

If using the CD/DVD Library MC-8100U/8200U/8600U, be sure to execute the auto drive detection mode after installing, adding, exchanging or removing drives, to prevent any malfunction.

1. While holding the “8” key on the control panel, turn on the power of the Library.

2. When the LCD display shows “DRIVE DETECTION COMPLETED”, turn off the power of the Library.

3. Turn the Library on again.

6