E
<MC-R434U connection example>
1.
Connect the power supply cable, control cable and SCSI
cable to the connectors at the rear of the MC-R434U.
䡵 When using the MC-8100LU, the No. of the cable must
always correspond to the No. of the drive bay to which it
is being connected. If a cable with the wrong number is
connedted, it will lead to the equipment malfunctioning.
䡵 When using an MC8200LU/8600LU, connect the con-
trol cables which lead from the side of the drive bay where
the MC-R434 is to be inserted.
䡵 Insert all connectors firmly.
䡵 SCSI cables are connected as a daisy chain connec-
tion. Each connector should be connected to the drive
positions as illustrated in the diagram.
•The SCSI cable, which is built into the MC-8100LU/
8200LU/8600LU standard models, terminates at the
location where the connection is physically terminated.
<MC-R434U rear panel>
Interior
Drive 4
Drive 3
Drive 2
Drive 1
Library SCSI board
Drive 6
Drive 5
Terminator
Internal SCSI (LVD) cable
68-pin external SCSI connector
To host computer (SE/LVD)
SE-LVD conversion board
Terminator
Internal SCSI (SE) cable
Power cable
Control cable
DIP switch
SCSI cable
14p
3
4p
2
3
1

Procedure for Connecting the Cables to

the Back of the MC-R434U

1.
Insert the MC-R434U from the rear of the CD/DVD Library
䡵Be sure not to damage the sensor slit.
䡵Make sure that the direction of the MC-R434U is correct
when inserting it.
䡵Be sure that the cables connected to the rear of the CD/
DVD Library are not caught or pinched when inserting
the MC-R434U.
2.
Insert the MC-R434U slowly until the screw installation hole
located on the side of the MC-R434U and the screw instal-
lation hole located on the drive locking section are aligned.
3.
Screw in the provided drive locking screw to the screw in-
stallation hole of the drive locking section.
䡵Tighten the screw firmly.
䡵If the drive locking screw is loose, the drive and/or Li-
brary may be damaged.
Sensor slit
MC-R434U
Drive locking
screw
MC-R434U
<MC-R434U insertion direction>
<MC-R434U locking method>

Procedure for Installing the MC-R434U in

the CD/DVD Library ●Connect the MC-R434U to the CD/DVD Library.

Also refer to the instruction manual for the CD/

DVD Library.

CONNECTION
03.11.17, 5:15 PM4