JVC CA-EX90 Setting the Clock, Use the remote control unit to set the clock, Why set the time?

Setting the Clock

This unit incorporates a clock with a 12-hour display. Be sure to set the clock before operating the unit. The clock can be set either in ON or STANDBY mode of power.

Use the remote control unit to set the clock.

/CLOCK TIMER

1Press CLOCK/TIMER.

/L	+	/	R
–

SET

To set the clock precisely

Blinks.

2Set the time of the day.

1Set the hour.

Use +/R or –/L to display the appropriate hour, then press SET.

Hold down +/R or –/L to change the hour sequentially.

After setting the hour (before pressing SET)

Blinks.

2Set the minutes.

Use +/R or –/L to display the appropriate minute, then press SET.

Hold down +/R or –/L to change the minutes in 10 minutes steps.

•If you set the clock while the power is on, the display returns to the previous information after completing the clock setting.

After setting the minutes, press SET in sequence with the time announcement on the TV, radio or telephone service. This starts the clock counting from 0 seconds of the set minute.

Why set the time?

Setting the time allows you to use the daily and recording timer operations.

The daily and recording timer operations cannot be set unless the clock has been set. To correct the previously set time, press CLOCK/TIMER repeatedly (5 times) so that the hour blinks to enter the clock set mode.

Notes

•Pressing buttons other than those described above while setting the clock will cancel the clock setup. If this occurs, resume setting the clock from step 1.

•In case of a power failure (or when the power cord has been unplugged) the clock may show the time of the power failure, or a blinking “AM 0:00”. If this occurs, reset the clock to the correct time.

19 CA-EX90