JVC LVT2190-006A, NX-PB10 Troubleshooting, References, iPod, Symptoms, Causes/Remedies

English

References

Troubleshooting

If you are having a problem with your System, check this list for a possible solution before calling for service.

	Symptoms	Causes/Remedies
	Power does not come on.	• Power plug is not inserted securely. Plug it in securely.
	Adjustments or settings are suddenly	• There is a time limit. Start the procedure again.
General	canceled before you finish.
	Unable to operate the System from the	• The path between the remote control and the remote sensor on
	remote control.	the System is blocked.
		• The battery is exhausted.
	No sound is heard.	• Headphones are connected.
radio	Hard to listen to broadcasts because of	• The FM antenna is not properly extended and positioned.
	noise.	• Electrostatic discharge from your body may cause noise. If this
FM		happens, turn the System off then on again.
iPod	The iPod does not play, but “IPOD” appears	• The iPod battery is low or exhausted. Charge the iPod battery.
	on the display.
	The disc/USB mass storage class device/SD	• The disc is placed incorrectly. Place the disc with the label side
	card does not play.	facing forward.
		• The disc is recorded using “packet writing (UDF file system).” It
		cannot be played.
		• The USB mass storage class device is not connected properly or
		the SD card is not inserted properly.
		• The CD-R/CD-RW is not be finalized correctly. Use finalized discs.
		• The CD pickup lens is dirty (see page 13).
Disc/USB/SD	“ NO DISC” or “NO SONG” appears on the	• MP3/WMA files are not recorded on the disc, USB mass storage
	display.	class device, or SD card.
	ID3 Tag on an MP3 file cannot be shown.	• There are two types of ID3 Tag—Version 1 and Version 2. This
		System can only show ID3 Tag Version 1.
	Groups and tracks are not played back as	• Playing order is determined when the groups and tracks are
	you expect.	recorded. It depends on the writing application.
	The disc/USB mass storage class device/SD	• The disc is scratched or dirty.
	card sound is discontinuous.	• MP3/WMA files have not been properly recorded onto the USB
		mass storage class device or SD card.
	Sound from the USB mass storage class	• Noise and static electricity may stop the sound. In this case,
	device/SD card is interrupted.	disconnect and connect the USB mass storage class device or
		remove and insert the SD card again after turning off the System.
	The disc/iPod door does not open or close.	• The AC power cord is not plugged in.
		• The disc/iPod door is locked. Unlock it (see page 6).
Timer	Daily Timer does not work.	• The System was turned on when the on-time came. The timer
		stars working only when the System is turned off.

• If the System does not work correctly, disconnect the AC power cord from the wall outlet, wait for a while, then connect the cord again.

• JVC bears no responsibility for any loss of data in USB mass storage class device, SD card, or iPod while using this System.

12