TROUBLESHOOTING
• If you are having a problem with your unit, check this | • If you cannot solve the problem from the hints given | ||||
list for a possible solution before calling for service. | here, or the unit has been physically damaged, call a | ||||
|
|
| qualified person, such as your dealer, for service. | ||
|
|
|
|
| |
| Symptom |
| Possible cause | Action | ||
|
|
|
|
| |
Power cannot be turned on. |
| The power cord is unplugged. | Connect the power cord. | ||
|
|
|
|
|
|
When PLAY 2 is pressed, tape does not |
| PAUSE 8 is pressed. |
|
| Press PAUSE 8 again to release it. |
move. |
|
|
|
|
|
|
|
|
|
| |
Playback sound is at a very low level. |
| • Batteries are run down. | • Replace the batteries with new ones. | ||
|
| • The head is dirty. |
|
| • Clean the head. |
|
|
|
|
| |
REC ¶ does not function. |
| • The safety tabs of the cassette have | • Reseal the slots with adhesive tape. | ||
|
| been broken off. |
|
|
|
|
| • No cassette is loaded. | • Load a cassette. | ||
|
|
|
|
|
|
English
The disc is loaded but does not play. |
| • The disc is upside down. |
|
| • The disc is dirty. |
|
| • The disc is damaged or warped. |
|
| • The lens is dirty. |
|
| • There is moisture condensation. |
|
|
|
No sound from the speakers. |
| Headphones are connected. |
|
|
|
Since the tape speed is irregular, wow |
| • The pinch roller or capstan is dirty. |
and flutter occur. |
| • Batteries are run down. |
|
|
|
Radio reception is poor and there is |
| The antenna is not properly adjusted. |
much static. |
|
|
|
|
|
•Load the disc with the label side facing up.
•Clean the disc.
•Replace the disc with a playable one.
•Clean the lens.
•Turn the unit on and wait one or two hours before use.
Disconnect the headphones.
•Clean the pinch roller and capstan.
•Replace the batteries with new ones.
Adjust the antenna correctly.
Remote control is impossible. |
| • Batteries in the remote control unit are | • Replace the batteries with new ones. | |
|
| run down. |
| |
|
| • The remote sensor section is exposed | • Try not to operate the unit under direct | |
|
| to bright light (direct sunlight, etc.) | sunlight, etc. | |
|
|
|
|
|
Note:
When the unit is moved from a cold place of around 0˚C (32˚F) to a warm place, it may not operate normally, because moisture has formed inside the unit. Normal operation will be restored after waiting one or two hours.
22