JVC RX-558VBK manual Using the DVD Multi Playback Mode, Activating the DVD Multi Playback Mode

Using the DVD MULTI Playback Mode

This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DVD player. Before playing back a DVD, refer also to the manual supplied with the DVD player.

Activating the DVD MULTI Playback Mode

You can adjust the DVD MULTI playback mode while playing back a DVD using the analog discrete output mode on the DVD player. Once you made adjustments, the receiver memorizes the adjustments until you change them.

Before you start, remember...

•Make sure that you have set the speaker information correctly (see page 11).

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•You can only adjust the rear and/or center speaker output levels when you have connected rear speakers and/or a center speaker and have set “REAR SPK” and/or “CNTR SPK” correctly. See page 11.

On the front panel:

DVD MULTI

1. Press DVD MULTI .

Note:

When you select “DVDMULTI” as the source to play, the DSP mode is canceled temporarily, and the SURROUND button does not work.

7. Press cursor control @/ #to adjust the left rear speaker output level (from –10 to +10).

8.Press cursor control %/ Þ repeatedly until “–REAR R+”

appears on the display.

9. Press cursor control @/ #to adjust the right rear speaker output level (from –10 to +10).

From the remote control:

1. Press DVD MULTI. DVD MULTI

Note:

When you select “DVDMULTI” as the source to play, the DSP mode is canceled temporarily, and the SURROUND button does not work.

2.Select the analog discrete output mode on the DVD player, and start playing a DVD.

• Refer to the manual supplied with the DVD player.

If you need to make any adjustment, go to the following steps.

3. Press ADJUST so that the cursor	ADJUST
control %/ Þ/ @/ #buttons work
for adjusting the DVD MULTI
playback setting.

2.Select the analog discrete output mode on the DVD player, and start playing a DVD.

• Refer to the manual supplied with the DVD player.

If you need to make any adjustment, go to the following steps.

3. Press SOUND CONTROL.	SOUND
	CONTROL

The 10 keys are activated for adjusting the sound.

4. Press cursor control % / Þ repeatedly until “–CENTER+” appears on the display.

5. Press cursor control @/ #to adjust the center speaker output level (from –10 to +10).

6. Press cursor control % / Þ repeatedly until “–REAR L+” appears on the display.

4.Press CENTER – / + to adjust the center speaker output level.

•Pressing CENTER – decreases the output level up to –10 dB.

•Pressing CENTER + increases the output level up to +10 dB.

5.Press REAR•L – / + to adjust the left rear speaker output level.

•Pressing REAR•L – decreases the output level up to –10 dB.

•Pressing REAR•L + increases the output level up to +10 dB.

6.Press REAR•R – / + to adjust the right rear speaker output level.

•Pressing REAR•R – decreases the output level up to –10 dB.

•Pressing REAR•R + increases the output level up to +10 dB.

– CENTER +

5 6 5

– REAR•L +

85 9

– REAR•R +

10 +10

20