JVC RX-D205S 1Press and hold STANDBY/ON VCR 2Press VCR, 4Release STANDBY/ON VCR, Standby/On Vcr

❏Changing the transmittable signals for operating a VCR

1Press and hold STANDBY/ON VCR.

2Press VCR.

3Enter the manufacturer’s code using buttons 1 – 9, and 0.

See “Manufacturers’ codes for VCR” on the right.

4Release STANDBY/ON VCR.

Now, you can perform the following operation on the VCR.

STANDBY/ON Turn on or off the VCR.

VCR:

After pressing VCR, you can perform the following operations on the VCR.

CHANNEL +/–:	Change the channel numbers on the
	VCR.
3:	Start playback.
7:	Stop playback.
8:	Pause playback.
FF:	Fast-wind a tape.
REW:	Rewind a tape.
REC PAUSE:	Enter recording pause. To start
	recording, press this button then 3.

See the instructions supplied with the VCR for details.

5Try to operate your VCR by pressing

STANDBY/ON VCR.

When your VCR turns on or off, you have entered the correct

code.

If more than one code is listed for your brand of VCR, try each

one until the correct one is entered.

Manufacturers’ codes for VCR

Manufacturer	Codes
JVC	01, 02, 03
Emerson	10, 22
Gold Star	11
Hitachi	04
Mitsubishi	12
NEC	21
Panasonic	07, 13
Philips	09
RCA	05, 06
Samsung	20
Sanyo	17, 18, 19
Sony	14, 15, 16
Zenith	08

Initial setting: 01

Manufacturers’ codes are subject to change without notice. If they are changed, this remote control cannot operate the equipment.

37