JVC SP-DWF10 English, SignalsAUTO POWER ON/STANDBY , Turning On the PowerPOWER

– 3 –

English

Operating the Unit Automatically According to the Incoming

To activate AUTO POWER ON/STANDBY.

Press the AUTO POWER ON/STANDBY switch to the [ ] ON

position.

•If no sound comes in for 5-10 minutes, the unit enters

standby mode. The power lamp lights in red.

•If the unit detects incoming signals, the unit starts

operating. The power lamp lights in green.

To cancel AUTO POWER ON/STANDBY.

Press out the AUTO POWER ON/STANDBY switch to set it to the

[ ] CANCEL position.

CANCEL

AUTO POWER ON / STANDBY

When the volume level of the amplifier is so low or the

incoming signals are so weak that this unit cannot detect

sounds, Auto Power On/Standby may not work correctly.

To turn on the power.

Press the POWER switch to the [ ❙ ] ON position.

•The power lamp lights in green.

To cut of the power.

Press the POWER switch to the [ ‡ ] OFF position.

•The power lamp goes out.

•This will disconnect the mains lead.

Operations

Front Rear

Power lamp

Connections

Before connecting this unit to the amplifier (or receiver), observe

the following carefully.

•Turn off the amplifier.

•Make all connections before plugging in this unit. •DO NOT connect this unit to the REC OUT jacks of your

amplifier. It may damage your subwoofer.

Amplifier or Receiver

To LINE OUT To SUBWOOFER OUT

or MONO

Stereo audio cord (not Supplied)

In the case that the receiver dose not have the SUBWOOFER OUT or MONO terminal.

Monaural audio cord (Supplied)

To an AC outlet

SP-DWF10_Eng.pm65 4/27/04, 9:24 AM3