Connection
7Connecting the speaker system to the amplifier
Before connection—
• Turn off the power to the amplifier before connecting the |
speaker system; otherwise, the speakers may be damaged. |
• The impedance of the speaker is 6 Ω. Before connecting it to |
your amplifier, check the speaker impedance range of your |
amplifier. If the impedance of this speaker is out of the speaker |
impedance range indicated on the amplifier, you cannot |
connect this system to the amplifier. |
• The maximum power handling capacity of the |
100 W. Excessive input will result in abnormal noise and |
possible damage. |
7Connecting the speaker cord
Connect the speaker cord to the speaker as illustrated.
•Make sure to match the polarity (ª and ·); otherwise, the surround effect will become less effective.
Before connecting:
Twist and remove the insulation at the end of each speaker cord.
• Be sure to turn down the volume level to prevent unwanted | |
noise before performing following operations: | |
– Turning on or off other components, | |
– | Operating the amplifier, |
– Tuning FM stations, | |
– | |
– | Continuously reproducing high frequency oscillation or high |
| pitch electronic sounds. |
• When using a microphone, do not aim it at the speakers or | |
use it near the speakers; otherwise, the howling which occurs | |
may damage the speakers. | |
• Before replacing the cartridge, always turn off the power to the | |
turntable; otherwise, the clicking noise may damage the | |
speakers. | |
• Speaker cords are supplied to the speakers. When using other | |
speaker cords, observe the following; | |
– Buy thick speaker cords rather than thin cords, and make | |
| them as short as possible for connection. |
– Use speaker cords of the same length for both left and right | |
| speakers. |
– Do not use long speaker cords; otherwise, the sound quality | |
| may deteriorate. |
– Using a special speaker cord such as a litz wire, a coaxial | |
| cable, or a cord which has the specified connecting |
| directionality may influence the sound quality. |
1Press | 2Insert |
Red (ª)
Black (·)
| Speaker terminals | |
| on the amplifier | |
White | RIGHT | LEFT |
| Black |
Right
speaker
3Release |
White |
Left |
speaker |
Specifications
Type: | |
| |
Speakers |
|
Woofer: | 10.0 cm cone x 2 |
Tweeter: | 4.0 cm cone x 1 |
Power handling capacity: 100 W
Impedance: | 6 Ω |
Frequency range: | 55 Hz to 20 000 Hz |
Sound pressure level: | 85 dB/W•m |
Dimensions (W x H x D): | 250 mm x 1065.5 mm x 310 mm |
Mass: | 7.2 kg |
Design and specifications subject to change without notice.