JVC SR- DVM600U Audio Dubbing (DV Deck Only), 54 EN EDITING, DVD, AUDIO, TV/DVD, AUDIO DUB, DV/HDD/DVD, INPUT SELECT, INPUT SELECT +/–, ARECB, Press, Press, Press

54 EN EDITING

	Audio Dubbing (DV Deck Only)	● Slide the TV/DVD switch to DVD.
		1 Connect an audio device to the unit’s [AUDIO] input connectors
This function allows you to record new audio, without erasing the
original audio, on a DV tape that was recorded with ADV AUDIO		on the front panel.
		● When using a monaural audio device, connect its AUDIO OUT
RECB set to A12BITB (A pg. 60).
		connector to the [AUDIO-L] input connector on your unit.

ATTENTION:

You cannot perform Audio Dubbing on a tape that was recorded with ADV AUDIO RECB set to A16BITB (A pg. 60), on a tape that was recorded at the ALPB speed, or on a blank tape.

Your unit Recorder

INPUT SELECT AUDIO DUB.

To [AUDIO] input

Audio cable (not supplied)

AUDIO OUT

CD player, etc.

	CD player, etc.
	Mixer output	Audio mixer
	Original sound
Your unit	[AUDIO OUTPUT]	Recorder

2Load a Mini DV cassette with the erase protection switch set to

ARECB.

3Press DV/HDD/DVD on the unit repeatedly or DV on the remote so that the DV lamp lights up on the unit.

4Press INPUT SELECT +/– on the remote control or INPUT SELECT on the unit to select AF-1B.

5Start playback slightly before the actual point from where you wish to start dubbing.

6Press W to pause playback.7Press AUDIO DUB. to engage the audio dubbing mode.●Your unit enters the Audio Dubbing Pause mode.

●To perform Audio Dubbing with audio mixing, press AUDIO to select AL W X RB at this point. When using the DV deck as the recording deck, also make sure that AAUDIO MODEB is set to ASOUND1B (A pg. 60).

*Audio Dubbing with audio mixing is not possible if you are using a monaural audio component, or if you don’t have an audio mixer.

8Engage the audio device’s playback, then press I to start the tape in the unit. Audio dubbing starts at this point.

●To stop dubbing temporarily, press W. Press I to resume dubbing.

9Press o on the unit, then stop playback on the audio device to end the audio dubbing.

NOTES:

●When monitoring the audio dubbed sound on the DV deck, set AAUDIO MODEB to ASOUND2B (A pg. 60).

●When playing back an audio dubbed Mini DV tape on the DV deck, set AAUDIO MODEB to ASOUND2B (A pg. 60).

●Audio dubbing is not possible using the [DV IN/OUT] connector.●Audio dubbing is not possible on a blank portion of the tape.

To	INPUT SELECT	AUDIO DUB.
[AUDIO]
input