JVC SR- DVM600U Connecting To A Dolby Digital Decoder, Or An Amplifier With Built-inDTS, NOTES:, program, CAUTIONS:, When you can’t switch the audio channel of a bilingual

		SYSTEM CONNECTIONS EN 57
Connecting To A Dolby Digital Decoder		1 Connect the unit and a Dolby Digital Decoder or an amplifier
		with built-in DTS using either an optional optical cable or an
Or An Amplifier With Built-in DTS		optional coaxial cable.
		NOTES:
These instructions enable you to connect your unit to a Dolby		● For Dolby Digital sound, set ADIGITAL AUDIO OUTB to ADOLBY
		DIGITAL/PCMB. (A pg. 58)
Digital Decoder or an amplifier with built-in DTS.
		● For DTS sound, set ADIGITAL AUDIO OUTB to ASTREAM/PCMB.
		(A pg. 58)
		CAUTIONS:
		● This unit has a dynamic range of more than 110 dB with regards
		to its Hi-Fi audio capability. It is recommended that you check the
		maximum level if you are going to listen to the Hi-Fi audio signals
		through a stereo amplifier. A sudden surge in the input level to
		the speakers may damage them.
		● Some speakers and televisions are specially shielded to prevent
		television interference. If both are of the non-shielded type, do not
Dolby Digital Decoder or		place the speakers adjacent to the TV set as this can adversely
		affect the playback picture.
amplifier with built-in DTS
	To DIGITAL AUDIO input	When you can’t switch the audio channel of a bilingual
		program
		When the unit is connected with a digital audio device using an
Coaxial cable	Optical cable	optional optical cable and ADIGITAL AUDIO OUTB is set to
(not supplied)	(not supplied)	ADOLBY DIGITAL/PCMB, it is not possible to switch the audio
		channel of a bilingual program recorded on a DVD-RAM or DVD-R/
To [DIGITAL AUDIO	To [DIGITAL AUDIO	RW (VR mode) disc. In this case, perform the following steps using
OUTPUT	OUTPUT (OPTICAL)]	the remote control to switch ADIGITAL AUDIO OUTB from ADOLBY
(COAXIAL)]		DIGITAL/PCMB to APCM ONLYB.
		A Press SET UP to access the Main Menu screen.
		B Press selection keys to select ADVD VIDEO SET UPB, then
		press G.
		C Press selection keys to select AAUDIO OUTPUTB, then press
		G.
	Rear of unit	D Press selection keys to select ADIGITAL AUDIO OUTB, then
		press ENTER.
		E Press selection keys to select APCM ONLYB, then press
		ENTER. (A pg. 58)
		F Press SET UP to complete the setting.
		G Press AUDIO to select the desired audio channel.

Note for connection:

Remove the protection cap from the optical cable.