JVC SX-DW55 operating instructions Powered Subwoofer, Instructions, Warnings, Cautions and Others

Models: SX-DW55

1 3
Download 3 pages 29.11 Kb
Page 1
Image 1
POWERED SUBWOOFER

POWERED SUBWOOFER

LVT1361-004A [B]

© 2005 Victor Company of Japan, Limited

SX-DW55

INSTRUCTIONS

Thank you for purchasing a JVC speaker.

Before you begin using it, please read the instructions carefully to be sure you get the best possible performance. If you have any questions, consult your JVC dealer.

0705NSMSANHCE

EN

— SAFETY INSTRUCTIONS —

“SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT”

This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured.

Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and interconnections between pieces of equipment) are properly made and in accordance with the manufacturer’s instructions.

Switch off and withdraw the mains plug when making or changing connections. Do consult your dealer if you are ever in doubt about the installation, operation or safety of your equipment.

Do be careful with glass panels or doors on equipment.

DON’T continue to operate the equipment if you are in any doubt about it working normally, or if it is damaged in any way—switch off, withdraw the mains plug and consult your dealer.

DON’T remove any fixed cover as this may expose dangerous voltages.

DON’T leave equipment switched on when it is unattended unless it is specifically stated that it is designed for unattended operation or has a standby mode.

Switch off using the switch on the equipment and make sure that your family know how to do this. Special arrangements may need to be made for infirm of handicapped people. DON’T use equipment such as personal stereos or radios so that you are distracted from the requirements of traffic safety. It is illegal to watch television whilst driving. DON’T listen to headphones at high volume as such use can permanently damage your hearing.

DON’T obstruct the ventilation of the equipment, for example with curtains or soft furnishing. Overheating will cause damage and shorten the life of the equipment.

DON’T use makeshift stands and NEVER fix legs with wood screws—to ensure complete safety always fit the manufacturer’s approved stand or legs with the fixings provided according to the instructions.

DON’T allow electrical equipment to be exposed to rain or moisture.

ABOVE ALL.

NEVER let anyone, especially children, push anything into holes, slots or any other opening in the case—this could result in a fatal electrical shock.

NEVER guess or take chances with electrical equipment of any kind—it is better to be safe than sorry!

IMPORTANT for the U.K.

DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer.

BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply. If this product is not supplied fitted with a mains plug then follow the instructions given below:

IMPORTANT:

DO NOT make any connection to the terminal which is marked with the letter E or by the safety earth symbol or colored green or green-and-yellow.

The wires in the mains lead on this product are colored in accordance with the following code: Blue : Neutral

Brown : Live

As these colors may not correspond with the colored markings identifying the terminals in your plug proceed as follows:

The wire which is colored blue must be connected to the terminal which is marked with the letter N or colored black.

The wire which is colored brown must be connected to the terminal which is marked with the letter L or colored red.

IF IN DOUBT - CONSULT A COMPETENT ELECTRICIAN.

Warnings, Cautions and Others

oCaution!

To avoid personal injury or accidentally dropping the unit, have two persons unpack, carry, and install the unit.

21 kg

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture. o Caution—POWER switch

This apparatus is provided with POWER switch to minimize power consumption for safe use. Therefore,

1.Before doing initial settings, complete all the connections required, connect the mains plug into the wall outlet, then set the POWER switch to ON [ B ].

The power lamp lights in green or red.

2.Press the AUTO ON / STANDBY switch to the ON [ A ] position.

If no sound comes in for a few minutes, the unit enters standby mode. The power lamp lights in red.

If the unit detects incoming signals, the unit starts operating. The power lamp lights in green.

3.Press out the AUTO ON / STANDBY switch to set it to the [ B ] CANCEL position. The power lamp lights in green.

4.When not in use, set the POWER switch to OFF [ A ]. This disconnects the main line.

oCautions

Do not block the ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.)

Do not place any naked flame sources, such as lighted candles, on the apparatus.

When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of these batteries must be followed strictly.

Do not expose this apparatus to rain, moisture, dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.

oCaution—Proper Ventilation

To avoid risk of electric shock and fire, and to prevent damage, locate the

apparatus as follows:

 

1. Front:

No obstructions and open spacing.

2.Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below.

3. Bottom:

Place on the level surface. Maintain an adequate air path for

 

ventilation by placing on a stand with a height of 10 cm or

 

more.

 

Front View

Side View

Front

 

20 cm

20 cm

 

 

 

15 cm

15 cm

20 cm

 

10 cm

oPrecautions for installation

To prevent deformation or discoloration of the cabinet, do not install the unit where it is exposed to direct sunlight or high humidity, and avoid installation near air conditioning outlets.

Speaker vibrations may cause howling. Place the unit as far away from the player as possible.

Take the occurrence of earthquakes or other physical shocks into consideration when selecting the installation place, and secure the unit thoroughly.

Tuner reception may become noisy or hissing if this unit is installed nearby the tuner. In this case, leave a more distance between the tuner and this unit or use an outdoor antenna for better tuner reception without interference from this unit.

The unit is magnetically shielded to avoid color distortions on TVs. However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the unit.

When placing this unit near a TV set, turn off the TV’s main power switch or unplug it before installing this unit.

Then wait at least 30 minutes before turning on the TV’s main power switch again.

Some TVs may still be affected even though you have followed the above. If this happens, move this unit away from the TV.

When the TV screen shakes, move this unit away from the TV to find a position where the screen doesn’t shake and then set the unit there.

Connections (Make all connections before plugging in this unit.)

Checking Your Amplifier

Before connecting this unit to your amplifier (or receiver), check what types of connecting terminals your amplifier has.

Follow the instructions below to find a proper connection method for your equipment.

Illustrations of jacks and terminals in this manual may be different from the ones actually used for your amplifier. The illustrations are of the most used type.

CAUTION

Before connecting this unit to the amplifier (or receiver), observe the following carefully.

Turn off the amplifier.

DO NOT use the INPUT 1 (LOW LEVEL) and INPUT 2 (HIGH LEVEL) terminals on the rear of this unit at the same time; otherwise, noise will be heard and may damage the unit.

DO NOT connect this unit to the REC OUT jacks of your amplifier.

First check whether your amplifier has a subwoofer output jack.

It is usually named and printed as the “SUBWOOFER OUT” or “SUBWOOFER.”

If you find it on your amplifier, follow Connecting Method A.

SUBWOOFER

OUTIf you cannot find any

oConnecting Method A

Preparation:

Use the supplied monaural audio cord.

If your amplifier has only a monaural line output (MONO) jack, connect it to the MONO jack of the INPUT 1 (LOW LEVEL) terminal.

Main (Front) Speakers (not supplied)

SUBWOOFER

OUT

Your Amplifier

Next check whether your amplifier has line output jacks.

They are usually named and printed as “LINE OUT” or “LINE OUTPUT.”

If you find them on your amplifier, follow Connecting Method B.

LINE OUT

L

If you cannot

 

find any

R

 

oConnecting Method B

Preparation:

Purchase a stereo audio cord at an audio shop or electric shop.

Main (Front) Speakers (not supplied)

LINE OUT

SX-DW55 L

INSTRUCTIONS R

Your Amplifier

Follow Connecting Method C.

This connection can be used for two amplifiers, by connecting the front speaker terminals of the amplifier (usually named and printed as “FRONT SPEAKERS” or “MAIN SPEAKERS”).

FRONT SPEAKERS

1

2

RIGHT LEFT

oConnecting Method C

Preparation:

Purchase speaker cords at an audio shop or electric shop.

FRONT SPEAKERS

1

2

RIGHT

LEFT

Your Amplifier

Speaker cords

(not supplied)

Main (Front) Speakers (not supplied)

 

 

 

 

 

Monaural audio cord

 

 

 

 

 

(supplied)

 

 

 

 

 

 

RIGHT

LEFT

VOLUME

CUT OFF

 

POWER

INPUT 1

 

MAX MIN

FREQUENCY

AUTO ON/

 

200Hz

50Hz

 

 

 

 

PHASE

STANDBY

 

 

 

 

 

 

ON OFF

(LOW LEVEL)

 

 

 

NORMAL

ON

 

 

 

 

REVERSE

CANCEL

 

 

 

 

 

INPUT 2

 

 

 

 

 

 

(HIGH LEVEL)

 

 

 

 

 

RIGHT

LEFT

MONO

(LOW LEVEL)

 

 

 

 

 

 

RIGHT

LEFT

 

 

 

OUTPUT

 

 

 

 

 

 

INPUT 1

 

 

 

 

 

 

(LOW LEVEL)

 

 

 

 

 

 

 

MONO

(LOW LEVEL)

RIGHT

LEFT

 

 

 

 

OUTPUT

 

 

 

 

 

 

 

 

 

To an AC outlet

 

 

SX-DW55

 

 

Memo

 

 

 

 

 

You can connect two or more subwoofer as desired with this

terminal.(LOW LEVEL)

OUTPUT

VOLUME

 

CUT OFF

 

POWER

MAX

MIN

FREQUENCY

AUTO ON/

200Hz

50Hz

 

 

 

 

 

 

PHASE

STANDBY

 

 

 

 

 

 

 

 

ON

OFF

 

 

 

 

NORMAL

ON

 

 

 

 

 

 

REVERSE

CANCEL

 

 

 

 

 

 

 

INPUT 2

 

 

 

 

 

 

 

(HIGH LEVEL)

 

 

 

 

 

 

RIGHT

LEFT

 

 

 

RIGHT

 

LEFT

 

 

 

 

INPUT 1

 

 

 

 

 

 

(LOW LEVEL)

 

 

 

 

 

 

 

 

MONO

 

(LOW LEVEL)

RIGHT

LEFT

 

 

 

 

 

OUTPUT

 

 

 

 

 

SX-DW55

 

Stereo audio cord (not supplied)

RIGHT LEFT

INPUT 1 Warnings, Cautions and Others21 kg (LOW LEVEL)MemoManual background

MONO (LOW LEVEL) OUTPUT

Manual background To an AC outlet

Right speaker

Left speaker

 

 

 

 

 

 

Speaker cords

 

 

 

 

 

 

 

(not supplied)

 

 

 

 

 

 

 

INPUT 2

 

 

 

 

 

 

 

(HIGH LEVEL)

 

 

 

 

 

 

RIGHT

LEFT

VOLUME

 

CUT OFF

 

POWER

 

MAX MIN

FREQUENCY

AUTO ON/

 

200Hz

50Hz

 

 

 

 

 

 

PHASE

STANDBY

 

 

 

 

 

 

 

 

ON

OFF

 

 

 

 

NORMAL

ON

 

 

 

 

 

 

REVERSE

CANCEL

 

 

 

 

 

 

 

INPUT 2

 

 

 

 

 

 

 

(HIGH LEVEL)

RIGHT

LEFT

 

 

 

 

RIGHT

LEFT

 

RIGHT

 

LEFT

 

 

 

 

INPUT 1

 

 

 

 

 

 

 

(LOW LEVEL)

 

 

 

 

 

 

 

 

MONO

 

(LOW LEVEL)

RIGHT

LEFT

 

 

 

 

 

OUTPUT

 

 

 

 

 

 

 

 

 

 

To an AC outlet

 

 

SX-DW55

 

 

Page 1
Image 1
JVC SX-DW55 operating instructions Powered Subwoofer, Instructions, Warnings, Cautions and Others, Memo, 21 kg