Connections | Do not connect the power cord until all other connections have been made. |
|
|
Connecting the satellite (front, center, surround) speakers
Before connecting the speaker cords;Twist and pull the insulation coat off and remove.
Front speakers | Powered subwoofer |
Speaker cord (supplied)
•Connect the black cords to the black (r) terminals.
•Connect the white cords to the (q) terminals referring to the table below:
| FRONT SPEAKERS (LEFT) | White |
| FRONT SPEAKERS (RIGHT) | Red |
| CENTER SPEAKER | Green |
| SURROUND SPEAKERS (LEFT) | Blue |
| SURROUND SPEAKERS (RIGHT) | Gray |
4Ω 16Ω | Center speaker | Surround speakers |
|
4 m | Black | White | |
4 m | |||
| |||
Speaker (rear side) |
| Red | |
|
| ||
| Black |
| |
Screw M4 x |
|
| |
40 mm |
|
| |
(supplied) |
|
|
Base plate | 10 m |
CAUTION
•When you connect speakers other than the supplied ones, use speakers of the same speaker impedance (SPEAKER IMPEDANCE) indicated near the speaker terminals on the rear of the powered subwoofer.
•DO NOT connect more than one speaker to one speaker terminal.
•When moving the speakers, do not pull the speaker cords; otherwise, the speakers may fall over, causing damage or injury.
•When holding a speaker, always grasp the lower portion.
•Do not lean against the speakers, as the speakers could fall down or break, possibly causing an injury. Especially be careful that children do not lean against them.
•Do not reproduce sounds at so high a volume that they are distorted; otherwise, the speakers may be damaged by internal heat buildup.
9