Operating external components with the remote control
The buttons described below are used on pages 12 and 13.
TV/VIDEO | TV | VCR/DBS |
VCR/DBS
VCR DBS
DBS
VCR
TV Remote control
VCR/DBS mode selector
(play button)
ENTER
REC
Number buttons
TV RETURN | 100+ |
NOTE
•Manufacturers’ codes are subject to change without notice.
•Set the codes again after replacing the batteries of the remote control.
Operating the TV
7To set the manufacturer’s codeYou can operate a JVC TV without setting the manufacturer’s code.
1 Slide the remote control mode selector to TV.2 Press and hold TV.Keep the button pressed until step 4 is finished.
3 Press ENTER.Examples:
For a Hitachi TV:
Press 1, then 0.
For a Toshiba TV:
Press 0, then 8.
Manufacturer | Code | Manufacturer | Code |
|
|
|
|
JVC | 01 | Samsung | 12 |
|
|
|
|
Hitachi | 10 | Sharp | 06 |
|
|
|
|
Magnavox | 02 | Sony | 07 |
|
|
|
|
Mitsubishi | 03 | Toshiba | 08 |
|
|
|
|
Panasonic | 04, 11 | Zenith | 09 |
|
|
|
|
RCA | 05 |
|
|
|
|
|
|
If there is more than one code listed for corresponding brand, try each one until you enter the correct one.
7OperationAim the remote control at the TV.
IMPORTANT
|
|
|
|
|
|
|
|
|
Before using the remote control to operate a TV; | ||||||||
• Set the remote control mode selector to TV. |
|
| ||||||
The following buttons are available: |
|
|
|
| ||||
|
|
|
| |||||
|
|
| ||||||
| ||||||||
|
| TV: | Turns TV on and off. |
|
| |||
|
|
| ||||||
TV VOL | Adjusts the volume. | |||||||
TV/VIDEO: | Selects the input mode (either TV or | |||||||
|
|
| VIDEO). | |||||
CHANNEL | Changes the channels. | |||||||
TV RETURN: | Alternates between the previously selected | |||||||
|
|
| channel and the current channel. |
12