Basic operations

See page 17 for button locations.

Optimizing the speaker settings [Smart Surround Setup]

Be sure to connect the surround speakers to the powered subwoofer before performing Smart Surround Setup function. (A pg. 10 or 11)

NOTE

•When you change the positioning of the speakers or listener, or replace the supplied speakers with other ones, perform Smart Surround Setup again.

•Before you start the following procedure, be sure to change the WRLS SP setting to OFF. (A pg. 36) After the procedure is completed, be sure to change the setting back to ON when you use the wireless receiver unit.

7While DVD is selected as the source and stopped

1 Take your position where you listen to the sound.2 Press and hold SMART S.SETUP.

“SETTING UP” flashes on the display window.

3 Press ENTER, press Cursor Y/5 to select the distance between the front speakers and the listening position, then press ENTER.

4 Press Cursor Y/5 to select START, then press ENTER.5 Clap your hands over your head once.6 Make sure that “COMPLETED !” appears on the TV screen, then pressSMART S.SETUP.

The system detects your clapping sound through the satellite speakers, then automatically makes the best settings for each speaker. “COMPLETED !” appears on the TV screen when Smart Surround Setup completes.

When “FAILED !” appears on the TV screen

The system could not detect the clapping sound correctly. In such a case, follow the instructions that appears on the TV screen.

•When the system detects the clapping sound as “FAILED !” three

times, set the distance (DISTANCE) and the output level (LEVEL) manually (A pg. 38).

To cancel

Press SMART S.SETUP.

NOTE

•You need to set the subwoofer’s output level (LEVEL) manually. (A pg. 19 and 38)

•In step 2, “SW ERROR” appears on the display window if the center unit and the powered subwoofer are not connected correctly by using the supplied system cord.

20