Advanced operations
See page 25 for button locations.
IMPORTANT
Before using the remote control for the following operation;
• Set the remote control mode selector to
AUDIO.
NOTE
Before you start operation;
•There is a time limit when doing the following steps. If the setting is cancelled before you finish, start from step 1 again.
1 Press SETTING.Example:
B A L : C E N T E R
2 Press Cursor Y/5to select the item you want to set.•BAL (Balance):
You can adjust the balance between the front left and front right speakers.
•DEC (Decode):
When you play an external source (AUX DIGITAL is selected as a source) that was encoded with Dolby Digital or DTS Digital Surround, the following symptoms may occur;
•No sound comes out at the beginning of playback.
•Noise comes out while searching for or skipping chapters or tracks.
AUT/PCM (Auto/PCM):
Normally select this. The system automatically detects the incoming signals.
DOLBY D: Select this if the symptoms above occur when playing a disc (or software) encoded with Dolby Digital.
DTS: Select this if the symptoms above occur when playing a disc (or software) encoded with DTS Digital Surround.
•WRLS SP (Wireless speaker):
You can activate or deactivate the wireless transmission function for the wireless receiver unit.
ON: | Select this when you connect the surround |
| speakers via the wireless receiver unit. |
OFF: | Select this when you connect the surround |
| speakers to the powered subwoofer. |
•WRLS CH (Wireless channel):
You can select the desired wireless channel (1, 2, 3, or 4) for the wireless receiver unit depending on the condition of the
reception. Note that the channel on the center unit and the wireless receiver unit should be the same. (A pg. 12)
Example:
B A L : R
The adjustment is set and the display automatically disappears a few seconds later.
NOTE
•When “DOLBY D” or “DTS” is selected, if a signal encoded with another digital format comes in, you cannot listen to the sound. (The GD or Cindicator flashes.)
36