E-10

1.
Lug plate
3.
2.
Camera unit
Base
Wrench
Silica gel

Mounting the Base to the Ceiling

Installation and connection
Remove the camera unit from the base and mount the base to the pipe.
•Do not remove the protective sheet affixed to the dome cover until installation work is
completed.
Removing the sheet during installation may result in scratching of the dome cover.
CAUTION
•When performing installation under rain-
ing conditions, take caution as not to al-
low rain to enter inside the unit.
•Always use the provided silica gel. When
not using the silica gel, the dome cover
of the camera lens may cloud as a re-
sult.
Dome
cover
1.
Remove the dome cover from the
base
Loosen the Tamper-resistant screws fix-
ing the dome cover (3 locations) by us-
ing the provided wrench and turning
counterclockwise.
2.
Remove the camera unit from the
base
Loosen the screws on the camera unit
in the order of and and remove
the camera unit from the base.
MEMO
Dome cover and camera unit are connected
by the safety cable and base.
3.
Insert the included Silica gel
Insert the provided silica gel in the Base
interior and hold using the lug plate.
MEMO
•Always replace the silica gel when recon-
necting/resetting during repair or mainte-
nance.
When replacing, use:
JVC parts No. LW40500-001A

E-11

English
4. 4.
Connecting the safety cable
To prevent dropping, connect the unit to
a sturdy location (ceiling slab or chan-
nel) and safety cable.
5.
Wrap seal tape
Wrap the screw section of the pipe with
at least 2 rolls of seal tape.
Wrap the seal tape where the pipe-hole
screws and pipe screws meet.
6.
Mount the base to the pipe
Screw in the base to the pipe by turning
it clockwise.
(Conduit hole: 19.1mm (3/4"))
When the Dome camera cannot be in-
stalled to the Ceiling (page 16)
When installing the Dome camera to the
electrical box (page 17)
7.
Fix the base to the ceiling
Securely tighten using screws suitable
for the mounting holes (ø4.4mm(11/64")).
12mm(15
/32")
or less
Pipe
CAUTION
•Since the camera unit and dome cover will be in a suspended state from the base by the
safety cable, the camera unit and dome cover will also move when mounting the base to
the pipe. Facing the camera lens to the dome-cover side at this time may cause scratch-
ing of the lens. Make sure the dome cover and camera unit are facing opposite sides.
•When screwing in the pipe into the conduit hole, do not screw in more than 12mm(15/32")
to prevent damage to the pipe interior.
5.
CAUTION
•For the used safety cable, pay particu-
lar caution to the length, strength, pull,
material (insulation), etc.
•Always use the screws (M4 X 8mm)
mounted on the unit.
CAUTION
Check to make sure there is no gap be-
tween the ceiling and base.
Seal tape
Safety cable
6.7.
Not
Supplied