6 7 8

6Audio output terminals (E. AUDIO MONITOR OUT)

Decodes EMBEDDED AUDIO signals and outputs them as analogue signals.

•See the table below for the combinations of the audio channels from the CH1 or CH2 terminal.

Audio output modes

Audio output terminals

 

 

 

CH1

CH2

1ch

channel 1

channel 2

2ch

channel 2

channel 2

 

 

 

3ch

channel 3

channel 4

4ch

channel 4

channel 4

 

 

 

5ch

channel 5

channel 6

 

 

 

6ch

channel 6

channel 6

7ch

channel 7

channel 8

 

 

 

8ch

channel 8

channel 8

1–2ch

channels 1+2

channels 1+2

 

 

 

3–4ch

channels 3+4

channels 3+4

5–6ch

channels 5+6

channels 5+6

 

 

 

7–8ch

channels 7+8

channels 7+8

 

 

 

1–4ch

channels 1–4

channels 1–4

5–8ch

channels 5–8

channels 5–8

 

 

 

AUTO

all channels

all channels

About the audio output level

•When several audio channels are output at the same time, the more channels that are selected, the lower each channel’s output level will be. (Each channel’s output level becomes half for “1–2ch,” quarter for “1–4ch.”)

•The “AUTO” setting mixes and outputs all channels the signal has. The output level is automatically set according to the number of channels.

NOTES:

•When you change the input to INPUT A or B, the audio signals and channels of INPUT C or D selected last time are output from these terminals.

•The audio signal is output from these terminals only when the monitor is turned on.

To select the audio channel:

Using the MENU control, you can select the audio channel output from the audio output terminal.

☞“4 MENU control” on page 4

•Set the group of the audio output modes you want to select beforehand.

☞ “E. AUDIO GROUP” on page 14

7E. AUDIO SDI terminals (IN C, IN D)

Accepts the following signals.

•SMPTE259M SD SDI signal

•EMBEDDED AUDIO signals including up to 8 audio channels with the sampling frequency of 48 kHz.

About the AUDIO LEVEL METER function

You can check the conditions of the current EMBEDDED AUDIO signals on the AUDIO LEVEL METER display. You can turn on/off the AUDIO LEVEL METER display or change its setting using SET-UP MENU.

☞“STATUS DISPLAY” on pages 16 and 17

8SWITCHED OUT terminal

Outputs the re-clocked signals.

•The input signal (INPUT C or D) currently selected is output from this terminal.

NOTES:

•When you change the input to INPUT A or B, the signal of INPUT C or D selected last time is output from this terminal.

•The signal is output from this terminal only when the monitor is turned on.

7