5UNDER SCAN button

Reduces the screen size so that the whole screen is displayed.

6SCREENS CHECK button

Only the selected luminance signal or RGB element of a video signal is displayed. Each time you press this button, the screen changes in the following

order:

Normal screen = Monochrome screen =

Red screen = Green screen = Blue screen = (back to the beginning)

7MARKER button

Turns the MARKER function ON/OFF.

•MARKER function includes MARKER SELECT, ASPECT SELECT, and SAFETY MARKER functions.

☞ “MARKER” on page 12

NOTES:

•Functions do not operate when they are set to “OFF” in the “MARKER” menu.

•Initial setting of each function in the “MARKER” menu is “OFF.” Before you use the MARKER function, you must change the “MARKER” menu settings first.

8INPUT SELECT buttons/lamps

Select an input to display.

A:Select the video signal input to the VIDEO A terminal.

B:Select the video signal input to the VIDEO B terminal.

C:Select the signal input to the E. AUDIO SDI IN C terminal.

D:Select the signal input to the E. AUDIO SDI IN D terminal.

•The corresponding lamp of the input currently selected lights up.

9Power lamp

Unlit: The main power is off.

Orange: The main power is on and the monitor is in stand-by mode.

Green: The monitor is on.

pStand-by button

Turns on and off the monitor when the main power is on.

NOTES:

•Turn on the main power by using the main power switch on the rear panel.

•You can set the delay time between when the stand-by button is pressed and when the monitor actually turns on. ☞ “RUSH DELAY TIME” on page 14

7About the status display

Displays information of the current input selection and the monitor settings for about 3 seconds.

To show the status display, set “STATUS DISPLAY” to “AUTO” or “MANUAL” beforehand.

☞“STATUS DISPLAY” on page 16

Pressing the INPUT SELECT button currently selected shows the status display.

NOTE:

•When “STATUS DISPLAY” is set to “AUTO,” the status display also appears on the screen if you change the inputs or the signal condition changes.

1Input status

2Signal format

•“NO SYNC” is displayed when no video signal is input or no synchronized signal is detected.

•If “NO SYNC” is displayed even though a video signal is input, check the setting of “SYNC SELECT.”

☞ “SYNC SELECT” on page 14

•“Out of range” is displayed when a noncompliant signal is input.

3Setting of “COLOR TEMP.”

☞ “COLOR TEMP.” on page 15

“* ” is displayed if white balance is adjusted in the “COLOR TEMP./BAL.” menu.

4Appears when “SYNC SELECT” is set to “EXT.” (External synchronization)

☞ “SYNC SELECT” on page 14

5Setting of UNDER SCAN

☞ “5 UNDER SCAN button” on the left column

OVER: Over-scan

UNDER: Under-scan

6Setting of SCREENS CHECK

☞“6 SCREENS CHECK button” on the left column

COLOR: Normal screen

MONO: Monochrome screen

R ONLY: Red screen

G ONLY: Green screen

B ONLY: Blue screen

7Setting of MARKER

☞ “7 MARKER button” on the left column

5