JVC UX-5000 manual Adjusting the Volume, Reinforcing the Bass Sound, Tone Control BASS/TREBLE

Adjusting the Volume

Turn the VOLUME control of the Unit clockwise to increase the volume or counterclockwise to decrease it.

OR

With the System turned on, press the VOLUME + button on the Re- mote Control to increase the volume or press the VOLUME – button to decrease it.

CAUTION: DO NOT turn on the System and/or start playing any source without first setting the VOLUME control to minimum, as a sudden blast of sound could damage your hearing, speakers and/ or headphones.

For private listening

Connect a pair of headphones to the PHONES jack. No sound comes out of the speakers.

Be sure to turn down the volume before connecting or putting on headphones.

Reinforcing the Bass Sound

(AHB SUPER PRO)

You can reinforce the bass sound to maintain rich, full bass at low volume (you can use this effect only for playback):

To get the effect, press the AHB (Active Hyper Bass) SUPER PRO button on the Unit or the Remote Control.

The “BASS” indicator lights up on the display. To cancel the effect, press the button again. The “BASS” indicator goes out.

Tone Control (BASS/TREBLE)

You can control the tone by changing the bass and treble.

BASS Control ———————————

You can adjust the bass level (low frequency range level) between –6 and 6. (0: Flat)

■1. Press the BASS button on the Remote Con- trol.

■2. Press the UP or DOWN button on the

Remote Control to adjust the bass level.

BASS

DOWN UP

TREBLE Control ——————————

You can adjust the treble level (high frequency range level) between –6 and 6. (0: Flat)

■1. Press the TREBLE button on the Remote

Control.

■2. Press the UP or DOWN button on the

Remote Control to adjust the treble level.

TREBLE

DOWN UP

Showing the Time (DISPLAY)	English
In addition to a standard digital clock, an analogue clock (which ad-
vances every five minutes) can be displayed. The clock display or-
der varies according to the System mode:
In Standby mode ——————————

Every time you press the DISPLAY button on the Remote Control (or the CLOCK button on the Unit), the clock display changes as shown below.

Digital Clock + Analogue Clock = Analogue Clock = Digital Clock = (back to the beginning)

When the System is turned on ———

Every time you press the DISPLAY button on the Remote Control (or the CLOCK button on the Unit), the time display changes as fol- lows:

Current Source + Analogue Clock = Analogue Clock = Digital Clock = Current Source = (back to the beginning)

Note: The clock must be set to the correct time first. (See “Setting the Clock” on page 13.)

7