English

Playing Back from the PC

This System is equipped with a USB terminal on the front panel of the main unit. You can connect your PC to this terminal and enjoy sound reproduced through your PC. When you connect your PC for the first time, follow the procedure below.

•Remember you cannot send any signal or data to your PC from this System.

How to install the USB drivers

1Turn on your PC and start running WindowsR 98, WindowsR 98SE, WindowsR Me, WindowsR 2000, or WindowsR XP.

•If the PC has been turned on, quit all the applications now running.

2Select USB as the source.3Set the volume to minimum.4Connect the System to the PC using a USB cable (not supplied).

(front panel)

PC

 

USB cable

 

•Use “USB series A plug to B plug” cable when connecting.IMPORTANT

•Always set volume to “VOL-MIN” when connecting or disconnecting the other equipment.

5The USB drivers are installed automatically.
To play back sounds on the PCPress USB, then start playback from PC.

Refer to the manuals supplied with the sound reproduction application installed in the PC.

*MicrosoftR, WindowsR 98, WindowsR 98SE, WindowsR Me, WindowsR 2000 and WindowsR XP are registered trademarks of Microsoft corporation.

memo

•DO NOT turn off the unit or disconnect the USB cable while installing the drivers and for several seconds while your PC is recognizing the receiver.

•Use a full speed USB cable (version 1.1). Recommended cord length is shorter than approximately 2 m.

•If your PC does not recognize the unit, disconnect the USB cable and connect it again. If it does not work yet, restart Windows.

•The installed drivers can be recognized only when the USB cable is connected between the unit and your PC.

•The sound may not be played back correctly—interrupted or degraded—due to your PC settings and PC specifications.

13