JVC UX-J60 manual Playing Back Tapes, Playing Back a Tape, Press Push Open 0 on the unit

Playing Back Tapes

You can play back type I tapes.

Playing Back a Tape

1 Press PUSH OPEN 0 on the unit.

PUSH OPEN

2 Put a cassette in with the exposed part of the tape down.

3 Press PUSH OPEN 0 again to close the cassette holder.

4 Press TAPE 2 3. TAPE

The unit automatically turns on and the tape starts playing. The tape direction indicator (3 or 2) flashes slowly on the display.

•Each time you press the button, the tape direction changes:

3 : plays the front side.

2 : plays the reverse side.

When the tape plays to the end, the deck automatically

stops if the Reverse Mode is set to or . (See “To play both sides—Reverse Mode.”)

If no cassette is inserted when you press TAPE 2 3

“NO TAPE” appears on the display.

To stop playing, press 7.

To fast-wind to the left or to the right, press ¢ or 4 while the tape is not running.

The tape direction indicator (3 or 2) starts flashing rapidly on the display.

To remove the cassette, press PUSH OPEN 0 on the unit.

• If the tape is playing, stop it first.

To play both sides—Reverse Mode

You can set the deck to play just one side of a tape, both sides once, or both sides continuously.

Press REV.MODE (reverse mode).	REV.
	MODE

•Each time you press the button, the Reverse Mode changes as follows:

: The deck automatically stops after playing both sides of the tape. Stops when playback in the 2 direction is finished.

: The deck continues to play both sides of the tape until 7 is pressed.

: The deck automatically stops after playing one side of the tape.

•DO NOT open the cassette holder when the tape

is running.

•The use of C-120 or thinner tape is not recommended, since characteristic deterioration may occur and this tape easily jams in the pinch- rollers and the capstans.

17