Grizzly Essential Maintenance Tips for Your G0758 Drill

Table and Column Ways

Lube Type.. Model SB1365 or ISO 68 Equivalent

Lube Amount	Thin Coat
Lubrication Frequency	8 hrs. of Operation

Regular lubrication will ensure mill/drill performs at its highest potential. Regularly wipe table and column ways with recommended lubrication, then move components back and forth several times to ensure smooth movements (see Figures 34–36).

Z-Axis Ways

(1 of 2)

Figure 34. Z-axis way lubrication points.

Y-Axis Ways

Figure 35. Y-axis way lubrication points.

X-Axis Ways

Figure 36. X-axis lubrication points.

Model G0758 (Mfd. Since 2/14)

Z-Axis Leadscrews

Lube Type..Model T23964 or NLGI#2 Equivalent

Lube Amount	Thin Coat
Lubrication Frequency	120 hrs. of Operation

To lubricate Z-axis leadscrew:

1.DISCONNECT MACHINE FROM POWER!

2.Lower headstock as far as you can without contacting spindle to table surface.

3.Use mineral spirits and a brush to clean as much existing grease and debris off of Z-axis leadscrew shown in Figure 37 as possible. Allow leadscrew to dry.

Z-Axis

Leadscrew

Figure 37. Z-axis leadscrew lubrication point.

4.Using a brush, apply NLGI#2 grease to exposed leadscrew threads, then move head- stock through its full range of motion several times to disperse grease along full length of leadscrew.

-29-