Installing/Removing
Tooling
The Model G0758 includes a
Tool Slot
Figure 26. 1–13mm drill chuck joined with R-8
arbor.
Cutting tools are sharp and can easily cause cutting injuries. Always protect your hands with leather gloves or shop rags when handling cutting tools.
Installing Tooling |
|
Tools Needed | Qty |
Spindle Pin | 1 |
Wrench 8mm | 1 |
To install tooling: |
|
1.DISCONNECT MACHINE FROM POWER!
2.Remove drawbar cap (see Figure 27).
Drawbar Cap
Figure 27. Location of drawbar cap.
Model G0758 (Mfd. Since 2/14)
3. Align tool slot (see Figure 26) with pin inside spindle, then insert tooling into spindle until in contacts drawbar.
Note: Height of drawbar inside spindle can be changed by rotating adjustment nut (see Figure 28).
Drawbar |
Adjustment |
Nut |
Drawbar |
Spindle Pin |
Figure 28. Components used when installing or
removing tooling.
4. Working from above, thread drawbar by hand into tooling until it is snug.
5. Secure spindle with spindle pin and tighten drawbar with wrench, as shown in Figure 28.
Note: Do not overtighten drawbar. Overtightening makes tool removal difficult and will damage arbor and threads.
