Switch Housing and Light Kit
Holliston™
Adaptor Installation - Continued ( NO LIGHT KIT)
Step 12e. Locate the bottom cap and screw as shown in Figure #5, using the screw that you earlier removed from the light kit adaptor assembly (see step 11c) and insert cap screw through the hole in the center of the cap and attaching the cap the bottom of the fan as shown in Figure #5 on this page. Then tighten the screw with the provided screwdriver.
Step 12f. Locate the end cap screw plug shown in Figure #6, align and insert the two (2) holding tabs located on the screw plug with the slots located in the center of the end cap, then press on the plug locking end cap screw plug into place also as shown in Figure #6 and Figure #7.
PLUG
TABS
END CAP
SCREW Figure #6
PLUG
BOTTOM
CAP
CAP SCREW
Figure #5
END CAP
SCREW
PLUG
Figure #7
Switch Housing and Light Kit
Adaptor Installation ( NO LIGHT KIT ) - END
NOTE: To continue installation instruction, go to
Figure #8
17
