Casablanca Fan Company C31UxxZ LIGHTBULB INSTALLATION uplight, Hanging the Fan, Figure #6

Holliston™

Fan Preparation - continued

Step 4e. Slide the hanging adapter cover down over the motor coupling as shown in Figure #6, making sure that the adapter cover is covering the motor coupling as in shown Figure #7.

HANGING	HANGING
ADAPTER
	ADAPTER COVER
COVER
MOTOR
COUPLING

Figure #6 Figure #7

LIGHTBULB INSTALLATION (uplight)

Install Lightbulbs:

Step 5. Insert the six 7-watt lightbulbs for the uplight as shown in Figure #1.

(6)7-watt

Uplight Bulbs

NOTE: When replacing these lightbulbs, be sure to use only 7-watt maximum.

Figure #1

CANOPY COVER

RING

LIGHTBULBS

Hanging the Fan

Step 6a. To hang the fan body in the canopy, hold the fan body firmly and insert the ball into the canopy opening. Check that no wires are pinched. Rotate the fan body until the slot in the ball fits into the pin opposite the canopy opening.

Step 6b. Trim excess motor wires, leaving at least 6 inches above the downrod. Strip 1/2-inch insulation from the end of each wire using a wire stripper (available at your local hardware store).

BALL

SLOT

PIN

11