Casablanca Fan Company C31UxxZ Operation Power, Operation Speed Control, Operation lights

®3

	Operation Power
The	button is normally left in the on position. Always turn the power off

during cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter additional programs.

The	button must be left on to retain a previously set fan speed or light
level.

Operation Speed Control

There are six individual speed settings for the fan; each speed is indicated by an audible tone of increasing pitch.

To select the desired fan speed:

1.With fan off, press and hold the button labeled . The fan blades will start rotating at the slowest speed, and will increase in steps.

2.Release the button when the desired speed is reached.

The fan speed is now in memory and will automatically come on at the

same speed each time the	button is used. To maintain this level
of speed, turn the fan on by pressing		less than one second. To

lower speed, turn fan off, then on by pressing and holding the button until the desired speed is reached. When the fan is on, you may

increase the speed by pressing and holding the	button until the
desired speed is reached, then release it.

Fan Control

ON - OFF:

A momentary

press of the FAN

button

Change

speed:

Press and hold

FAN button

longer than one

second

Operation Reversing Airflow

The direction of airflow can be changed from down- ward to upward or from upward to downward.

To reverse the airflow:
1. Make sure the	is on and blades are Turn-
ing.
2. Press the	button.

Note: A four-toned signal indicates the command was accepted by the fan. A few seconds later the fan will slow to a stop and then reverse direction.

Operation lights

To turn the lights off and on, press and release the			button for less than
one second.
1.	First press/release of the	button- Both lights shall turn ON.
2.	Second press/release of the	button- Both lights shall turn OFF.
3. Third press/release of the		button – Downlight turns ON only.
4.	Fourth press/release of the	button – Downlight turns OFF.
5.	Fifth press/release of the	button – Uplights turns ON only.
6.	Sixth press/release of the	button - Uplights turns OFF only.

To vary the light brightness at each touch level:

Make sure where you are in the sequence to the right.

To dim both lights at the same time:

1.Make sure you have the uplight on.

2.Turn the light off, then press and hold the button. After one second, both lights will come on at their lowest setting and gradually become brighter or dim-

mest level if you continue holding the button.

3.Release the button when the desired brightness is reached.

Light Control

ON - OFF:

A momentary press of the

LIGHT button

Change brightness:

Press and hold

LIGHT button lon-

ger than one

second

26