® 3
In the wall bezel replacement
WALL CONTROL AND Hardware (not to scale)
Switch Mounting
Screws (2)
Switch Bezels |
|
| Wall Plate Screws (4) Wire Cap | |
White Wall | Almond Wall | (2) White | ||
Wall Control | (1) White | (2) Almond | ||
| (1) Almond | Plate(1) | Plate(1) |
|
|
|
|
|
|
Warning!
To avoid possible electrical shock, make cer- tain that electricity is turned off at the circuit breaker or fuse box before attempting any in- stallation or repair procedure
CAUTION! NOT turning the power OFF at the circuit breaker or fuse box may cause damage to the electronics within the wall control and/ or the PC board on the fan.
SCREWS
(2)
White Wall
Figure #1
Step 1a. Locate the two (2) screws holding the switch plate to the wall control and remove the cover plate as shown in Figure #1.
Step 1a. Locate the four (4) tabs holding the bezel to the front of the switch, then press in on each tab one at a time, removing the bezel as shown in Figure #2.
Step 1b. Locate the rubber key pad attached to the four (4) locating pins as shown in Figure #2 and remove rubber key pad from the WHITE bezel, also as shown in Figure #2.
BEZEL
BEZEL TABS
Figure #2
30
