Holliston™
Fan Installation
Getting Started
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish to place your Casablanca fan, an approved ceiling fixture outlet box must be installed and wired.
warning!
To reduce the risk of fire, electrical shock, or personal injury, mount to outlet box marked “Acceptable Fan Support of 22.7 kg (50 lbs.) or less” using the mounting hardware provided with the outlet box.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either the circuit breaker or fuse box), lower the old fixture and disconnect the wiring. Check the ceiling fixture outlet box to be sure it is marked “Approved for Ceiling Fan Mounting.” If it is not, a new box must be installed.
Note: The weight of this fan is 26 pounds.
Ceiling plate Installation
Ceiling Hardware (not to scale)
|
|
| Screw Pack: |
|
|
|
| Lag Screw and Washer (1) | Wire Nut (4) |
| Ceiling Plate | 1" x |
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Note: After removing the old fixture, check the outlet box to ensure that it is supported by a joist or beam across its upper surface. If not, a 2 x 4 stud must be installed.
Step 1a. Remove the knockout plug in the center of the outlet box or drill a
Step 1b. Route the outlet box wires through the hole of the ceiling plate as shown. Attach the ceiling plate
JOIST
CEILING FAN-
APPROVED
WIRING BOX
to the outlet box with the screws provided, making sure the outlet box wires are not being pinched.
CAUTION:
CEILING
PLATE
CEILING WIRING
To reduce the risk of personal injury, use only the mounting hardware provided with the approved outlet box to install the ceiling plate.
Outlet Box
Hardware
WASHERS
7
