Headstock
Movement
The headstock moves in the following ways:
•Travels up and down the column
•Tilts 45° left or right relative to the table.
Raising/Lowering Headstock
1.DISCONNECT MACHINE FROM POWER!
2.Loosen both
Lock
Levers
Figure 20. Location of Z-axis lock levers.
3.Use vertical handwheel shown in Figure 21 to adjust headstock height.
Vertical
Handwheel
Figure 21. Location of Z-axis handwheel.
4.Retighten lock levers.
Tilting Headstock |
|
Tools Needed | Qty |
Wrench 19mm | 1 |
Wrench 14mm | 1 |
To tilt headstock: |
|
1.DISCONNECT MACHINE FROM POWER!
2.Support headstock with one hand, then loos- en headstock center bolt and angle lock nut (see Figure 22).
Center Bolt
Angle
Lock Nut
Tilt Scale
Figure 22. Headstock tilt controls.
3.While watching tilt scale, rotate headstock to required angle, then retighten center bolt and angle lock nut to secure headstock.
Model G0758 (Mfd. Since 2/14) |
