Bosch Appliances FW5 software manual Interfaces, Alarm input, Relay

84 en Interfaces Camera Browser Interface

14 Interfaces

Interfaces

>Alarm input

>Relay

>COM1

14.1Alarm input

Configure the alarm triggers for the camera.

Select N.C. (Normally Closed) if the alarm is to be triggered by closing the contact.

Select N.O. (Normally Open) if the alarm is to be triggered by opening the contact.

14.1.1Name

Enter a name for the alarm input. This is then displayed below the icon for the alarm input on the LIVEPAGE (if configured).

14.2Relay

Configure the switching behavior of the relay output.

Select different events that automatically activate an output. For example, turn on a floodlight by triggering a motion alarm and then turn the light off again when the alarm has stopped.

14.2.1Idle state

Select Open for the relay to operate as an N.O. contact, or select Closed if the relay is to operate as an N.C. contact.

14.2.2Operating mode

Select the way the relay works.

14.2.3Relay follows

Select the event that triggers the relay.

AM18-Q0605 v5.0 2011.07 Software manual Bosch Security Systems