Camera Browser Interface

Encoder Settings en 51

 

 

10.1.3Profile name

If required, enter a new name for the profile.

10.1.4Target bit rate

To optimize use of the bandwidth in the network, limit the data rate for the camera. The target data rate should be set according to the desired picture quality for typical scenes with no excessive motion.

For complex images or frequent changes of image content due to frequent movements, this limit can temporarily be exceeded up to the value entered in the Maximum bit rate field.

10.1.5Maximum bit rate

This maximum data rate is not exceeded under any circumstances. Depending on the video quality settings for the I-frames and P-frames, this can result in individual images being skipped.

The value entered here must be at least 10% higher than the value entered in the Target bit rate field. If the value entered here is too low, it is automatically adjusted.

10.1.6Encoding interval

The Encoding interval slider determines the interval at which images are encoded and transmitted. This can be particularly advantageous with low bandwidths. The image rate in ips (images per second) is displayed next to the slider.

10.1.7Standard definition video resolution

Select the desired resolution for the standard definition video image. The following resolutions are available:

240p

352 × 240 pixels (displayed as 432 x 240)

480p

704 × 480 pixels (displayed as 854 x 480)

Note:

These resolutions are not used by a HD stream.

Bosch Security Systems

Software manual

AM18-Q0605 v5.0 2011.07

Page 51
Image 51
Bosch Appliances FW5 software manual Profile name, Target bit rate, Maximum bit rate, Encoding interval