Internet Explorer Setting

Settings (continued)

Protocol Page (continued)

B Protocol Settings (continued)

 

 

 

 

 

HTTP Server Port

 

You can change the port number for the built-in HTTP server of

 

 

 

the camera.

 

 

 

[Set values: 1 to 80 to 65535]

 

 

 

Memo:

 

 

 

 

 

 

 

 

 

● To access the camera from Internet Explorer, enter the

 

 

 

following in the Internet Explorer address bar when the camera

 

 

 

is set to its default settings.

 

 

 

http://192.168.0.2

 

 

 

If the port number has been changed to 8080, enter it after the

 

 

 

IP address as follows.

 

 

 

http://192.168.0.2:8080

 

 

 

 

Enter [:] and the port number

 

 

 

● If you change the HTTP server port, the port for the video

 

 

 

stream deliver request also changes.

 

 

 

 

 

 

 

 

 

 

HTTPS Server Port

 

You can change the port number for the built-in HTTPS server of

 

 

 

the camera.

 

 

 

[Set values: 1 to 443 to 65535]

 

 

 

Memo:

 

 

 

 

 

 

 

 

 

● To access the camera from Internet Explorer, enter the

 

 

 

following in the Internet Explorer address bar when the camera

 

 

 

is set to its default settings.

 

 

 

https://192.168.0.2

 

 

 

If the port number has been changed to 8080, enter it after the

 

 

 

IP address as follows.

 

 

 

https://192.168.0.2:8080

 

 

 

 

Enter [:] and the port number

 

 

 

● If you change the HTTPS server port, the port for the video

 

 

 

stream deliver request also changes.

 

 

 

 

 

 

 

 

 

 

SNMP

 

Sets SNMP.

 

 

 

[Set values: ON, OFF]

 

 

 

 

 

AMX Device Discovery

 

You can change the AMX device discovery protocol. Set this to

 

Protocol

 

"ON" when using the camera with an AMX system.

 

 

 

[Set values: ON, OFF]

 

 

 

 

 

 

 

 

 

* The [Set values] in bold letters are factory defaults.

62