Disclaimer
The Automatic Tracking feature is not a feature to prevent theft or fire. Our company shall not be liable for any inconveniences or failures that occur.
We shall not be responsible for any inconveniences or disturbances caused in the event of privacy invasion as a result of camera footages of this product.
Others
Do not subject the lens to strong light source such as sun rays. This may cause the equipment to malfunction.
This camera comes with a
While AGC is activated, if a transceiver which causes strong electromagnetic wave is used near the camera, the picture may suffer from beat. Please use the camera more than three meters away from such transceivers.
When automatic iris is selected, the Iris Control button may not work depending on the brightness of the screen (when the amount of light is not sufficient). In this case, set the iris to Manual.
When automatic iris is selected and AGC is ON, even if the iris setting can be changed with the Iris Control button, the Sense Up function will be enabled and the brightness of the screen may not change. In this case, set AGC to OFF or set the iris to Manual.
When this camera is used in the White Balance
If a high brightness object (such as a lamp) is shot, the image on the screen may have white vertical tailings. This phenomenon (smear) is characteristic of
Do not touch the dome cover with your hands. Dirty covers will cause image deterioration.
Do not subject the dome cover to strong impact. It may result in damage and water seepage.
The dome cover may fog due to the drastic change of temperature when humidity is high.
Do not connect an AC 24 V cable to AC 110 V/AC 230 V power supply. The camera will be damaged. If the wrong cable is connected, the internal circuit may be damaged. Do not use the camera. Bring it to your nearest JVC dealer for inspection.
To supply AC 24 V, use a AC 24 V supplying power unit that is insulated from AC 110 V/AC 230 V line.
When using multicast, make use of a IGMPv2- compliant network switch.
Some hubs/switches of products that are equipped with intelligent features may include a broadcast/ multicast suppression function. Viewing of multicast images on this product may fail if this function is enabled.
The electronic shutter of this product is set to 1/60 by default. For regions with a commercial power supply frequency of 50 Hz, switch to the 1/100 during use under fluorescent lights (excluding inverter lighting equipment) to prevent flickers.
When the B&W mode is set to AAutoB, the image turns
If the power supply voltage is momentarily cut off or reduced due to lightning or turning on of the air conditioner’s power, the image may be disrupted or noise interference may occur.
As the dome cover is of a semiglobular shape, image distortion will occur at the hemispherical edge. When the hemispherical edge of this unit is masked and horizontal level is shot in a tilt direction, the hemispherical edge will enter the field angle. This may cause the upper edge of the screen to become black and the focus unclear. In this case, you can avoid shooting the above area by using the tilt limit settings.
When shooting objects with a luminance difference or near a light source, ghost may occur on the screen. This is a feature of the dome cover and the
In particular, manual and auto pan operation near the TELE edge (telephoto side) may cause the screen to vibrate (unsmooth rotation). This is a feature of the motor and is not a malfunction.
As long magnification lens is used in this product, the focus may be unclear due to temperature changes but this is not a malfunction.
Preset the focus under an environment with a temperature closest to that in your actual usage. If the temperature change is large and the focus becomes unclear, preset the focus again before using the product.
If you sense that the focus has become unclear due to temperature changes, use the One Push AF function or reset the focus manually.
9