VARIOUS UNIQUE FUNCTIONS

Using a wireless microphone (only for XL-MV55GD)

A wireless microphone can be used with the XL-MV55GD player only.

Antenna preparations

You need to connect the FM antenna to the back of the player.

• Open the FM antenna wire connectors by pushing them to the side,

insert the FM antenna wires, and close the connectors by pushing

them back into their original position.

3.Set the MIC SELECT switch to “WIRELESS”.

4.When the WIRELESS MIC button turns green, the wireless microphone has been accepted. If the tuning is not proper (noise or no voice output from the speaker because of interfer- ence from TV signals etc.), the button turns red.

You can use up to four (4) microphones (3 wired and 1 wireless) at the same time.

5.The wireless microphone voice is mixed into MIC 3. Wireless microphone volume adjustment is performed with the MIC 3 knob.

• Attach the FM feeder antenna to the wall behind the player so that

the wire forms a “T” as illustrated.

FM feeder antenna

Note

MIC 3

MINMAX

WIRELESS

MIC ANT.

(Rear panel)

Microphone operation

1.Insert the antenna cable into the end of the microphone as illustrated and turn it clockwise to secure it.

 

WIRE-

 

LESS

 

OFF

FREQ. ADJUST screw

WIRED

MIC SELECT switch

* Be sure to set

 

the switch to

 

OFF when

 

you insert the

 

antenna cable.

 

Battery compartment cap

Antenna cable

2. Press the WIRELESS MIC button on the front panel.

WIRELESS

MIC

The maximum operating distance of the wireless microphone is about 10m. (This may change depending on room conditions.)

If there is interference when using the wireless microphone

If the WIRELESS MIC button turns green in spite of the microphone switch being off, or no voice is output from the speaker because of interference from TV signals etc., continue with the next step.

Operation

1.Try to tune the microphone frequency. First, adjust the FREQ. ADJUST screw in the rear panel using the provided screw- driver, until the interference is gone.

FREQ.

 

ADJUST

(Rear panel)

 

2.Then set the MIC SELECT switch to “WIRELESS”.

3.While speaking into the microphone continuously turn the microphone’s FREQ. ADJ screw with the provided screw- driver until the WIRELESS MIC button on the front panel button turns green.

Note

When you adjust the frequency, be sure to use the provided screw- driver. Metal head screwdrivers may not adjust correctly or may damage parts inside.

Page 16

Page 19
Image 19
JVC manual Using a wireless microphone only for XL-MV55GD, If there is interference when using the wireless microphone