Concerning Compact Discs
Only compact discs bearing this mark can be used with this unit.
However, continued use of irregular shape CDs
How to remove a disc from its case | How to store the disc in its case |
Label side up
How to hold a disc
If the disc surface is dirty
Wipe it with a damp cloth and then wipe dry.
Wipe from the center toward the outer edge.
Play surface (shiny surface)
PORTABLE CD PLAYER XL-PM25BK
For Customer Use:
Enter below the Model No. and Serial No. which are located either on the rear, bottom or side of the player. Retain this information for future reference.
Model No.
Serial No.
INSTRUCTIONS |
|
|
|
Supplied Accessories |
|
Check the packing carton for these accessories. |
|
AC adaptor | 1 pc. |
If moisture has formed on a disc
When moisture has formed because the disc was brought suddenly into a warm room from a cold environment, wipe off the moisture using a soft dry cloth.
When storing discs Avoid locations which are
•Exposed to direct sunlight.
•Susceptible to high levels of humidity or dust.
•Directly exposed to heat from a heating appliance.
•On top of a car dashboard or near the rear window.
Handling precautions
•On the label side (the side with writing) Do not write anything using a pencil,
•On the disc (shiny) side
Handle this side carefully to keep it free from fingerprints or scratches. Do not use record cleaners, solvents, etc.
•Do not attach labels or stickers to CDs. Do not use CDs with exposed adhesive from tape or left over peeled off stickers.
•Do not use
Stereo headphones | 1 pc. |
Remote control | 1 pc. |
Rechargeable batteries | 2 pcs. |
Use numbers in parentheses when asking for replacement parts. |
|
Thank you for purchasing this JVC product. Please read these instructions carefully before starting operation to be sure to obtain optimum performance and a longer service life from the unit.
EN | 0403SKMCREORI |
Precautions
Before using this unit, be sure to read the applicable items of the operating instructions and these
Safety
1. Care of AC adaptor - The cord of the AC adaptor should be |
routed so that they are not likely to be walked on or pinched by |
items placed upon or against them. Never take hold of the AC |
adaptor if your hand is wet, and always grasp the plug when |
connecting or disconnecting it. |
2. Disconnect when not in use - When not in use, be sure to |
disconnect the AC adaptor from the AC power outlet. |
3. Batteries - If the set is not used for a long period of time or is |
used only from an AC power source, remove all the batteries to |
prevent potential damage due to battery leakage. Do not mix |
(old and new ) batteries or different types of batteries. |
Maintenance
(See page 3 for details.)
Clean the cabinet, panel and controls with a soft cloth lightly moistened with mild detergent solution.
Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine.
Service
1.Damage Requiring Service - The unit should be serviced by qualified service personnel when:
(a)The AC adaptor is damaged; or
(b)Objects have fallen or liquid has been spilled into the unit; or
(c)The unit has been exposed to rain; or
(d)The unit does not appear to operate normally or exhibits a marked change in performance; or
(e)The unit has been dropped, or the enclosure damaged.
THE FOLLOWING NOTICES ARE APPLIED ONLY FOR THE U.S.A.:
POWERED BY
MUST BE RECYCLED OR DISPOSED OF PROPERLY.
ATTENTION:
The product that you have purchased is powered by a re- chargeable battery. The battery is recyclable. At the end of it’s useful life, under various state and local laws, it may be illegal to dispose of this battery into the municipal waste stream.
Check with your local solid waste officials for details in your area for recycling options or proper disposal.
RBRC
RBRC
Installation
■Environment
1.Condensation - Moisture may form on the lens in the follow- ing conditions…
•immediately after a heater has been turned on.
•in a steamy or very humid room.
•when the unit is suddenly moved from a cold environment to a warm one. If moisture forms inside this unit, it may not operate properly. To correct this problem wait about one hour for the moisture to evaporate.
■Placement
1.Foreign Material - Care should be taken so that objects do not fall into and liquids are not spilled into the unit. Do not subject this unit to excessive smoke, dust, mechanical vibration, or shock.
2.Magnetism - The unit should be situated away from equip- ment or devices that generate strong magnetic fields.
3.Stacking - Do not place any objects on top of the unit.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION!
THIS PRODUCT UTILIZES A LASER.
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL.
1.CLASS 1 LASER PRODUCT
2.DANGER: Invisible laser radiation when open and interlock failed or defeated. Avoid direct ex- posure to beam.
3.CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing to qualitied service personnel.
CAUTION!
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio fre- quency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to ra- dio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or tele- vision reception, which can be determined by turning the equipment off and on, the user is encouraged to try to cor- rect the interference by one of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and re- ceiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Any unauthorized changes or modifications to this equip- ment would void the user’s authority to operate this device.
1
