Precautions
•Install the System on a place which is level, dry, and neither too hot nor too cold; between 5°C and 35°C (41°F and 95°F).
•Do not use the System in a location near heat sources, or in a place subject to direct sunlight, excessive dust, or vibration.
•Leave sufficient distance between the System and the TV.•Do not insert any metallic objects or liquids into the System.•Do not handle the power cord with wet hands.•A small amount of power is always consumed while the power cord is connected to the wall outlet.
•Do not pull on the cord to unplug the power cord. When unplugging the power cord, always grasp and pull the plug so as not to damage the cord.
•There are no
•When away on holiday or for other reasons for an extended period of time, disconnect the power cord from the wall outlet.
•Stains on the System should be wiped off with a soft cloth. If the System is heavily stained, wipe it with a cloth soaked in water diluted neutral detergent and wrung well, then wipe clean with a dry cloth.
•If water gets inside the System, turn the power off and disconnect the power cord from the wall outlet, then call the store where you purchased this System. Using the System in this condition may cause a fire or electrical shock.
•Since the System may deteriorate in quality, become damaged or get its paint peeled off, be careful about the following:
–DO NOT wipe it forcefully.–DO NOT wipe it with thinners, benzines or other organic solvents including disinfectants.
–DO NOT apply any volatile substances such as insecticides to it.
–DO NOT allow any rubber or plastic to remain in contact with it for a long time.
About theThe speakers are magnetically shielded to avoid color distortions on TVs. If the color on a TV is distorted, perform the following procedure:
–Turn off the TV’s main power switch or unplug it before installing the System. Then wait at least 30 minutes before turning on the TV’s main power switch again.
Some TVs may still be affected even though you have followed the above procedure. If this happens, move the System away from the TV.
•When throwing away or saving the battery, wrap it in tape and insulate; otherwise, the battery may start to give off heat, crack, or start a fire.
•Do not poke the battery with tweezers or similar tools. Doing this may cause the battery to give off heat, crack, or start a fire.
•Dispose of battery in the proper manner, according to federal, state, and local regulations.
Basic Operation
1 Press to turn on the power. The standby lamp turns green.
2Press AUDIO IN DIGITAL,
AUDIO IN ANALOG, or iPod 6 to select the source.
iPod starts playing back. Go to step 4. For other equipment, go to step 3.
3Start playing back the
connected equipment.
4 Press VOL +/– to adjust the volume.
Rotating the dock
You can rotate the dock for iPod touch/iPod nano (4th Generation). To hold the iPod in place, attach the bracket (supplied) which fits your iPod to the dock.
DockBracket for iPod (supplied)• Attach hook side down. NOTE•While inserted into the dock, the battery of iPod is always charged through the System.
•Do not carry the System with iPod connected. You might drop the iPod or it might cause damage to the iPod or the System.
•Do not touch or hit the iPod terminal pins or connector pins in the dock directly. It might cause damage to the pins.
•Do not rotate the dock with excessive force.Compatible iPod modelsConnection
iPod nano 1GB/2GB/4GB | iPod classic 80GB/120GB/160GB |
iPod nano (2nd Generation) | iPod photo (4th Generation) |
To the wall |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
outlet |
|
|
| |||||
AC power cord | AC adaptor (supplied) | |||||||
(supplied) |
|
|
|
Stereo mini plug cable (not supplied)
Analog output of an audio playerCAUTION
Set the volume to the minimum level before starting playback. If the volume is set to a high level, the
2GB/4GB/8GB | 20GB/30GB/40GB/60GB |
iPod nano (3rd Generation) 4GB/8GB | iPod video (5th Generation) |
iPod nano (4th Generation) | 30GB/60GB/80GB |
8GB/16GB | iPod touch 8GB/16GB |
iPod mini 4GB/6GB | iPod touch (2nd Generation) |
iPod mini (2nd Generation) 4GB/6GB | 8GB/16GB/32GB |
iPod (4th Generation) 20GB/40GB |
|
If iPod does not play correctly, update iPod software to the latest version.
CAUTION
•DO NOT connect the power cord until all other connections have been made.•To avoid the risk of fire and to prevent damage,– Do not use any AC adaptors other than the one supplied. | * Compatible signal: |
– Do not use the supplied AC adaptor for other equipment. | sampling frequency). No |
Enjoying Surround Mode
• For details about updating iPod, check on the Apple web site <http://www. | |
| apple.com>. |
• | JVC does not assure the compatibility of iPod released after April |
| 2009 with this System. |
• | JVC is not responsible for any loss of or damage to iPod that might |
Using the core filter
Attach the provided core filter to the power cord to reduce interference.
1Release the stopper of thecore filter. | Stopper |
|
2Run the cable through the core filter, and wind the cable firmly once inside the cutout of the core filter as shown in the illustration.
Power cord5 cm (2 inches)3 Close the core filter until it clicks shut.CAUTION
Do not damage the cord by applying excessive force when winding.Preparing the remote control
When using the remote control for the first time, | Lithium coin battery |
pull out the insulation sheet. | (product number: CR2025) |
• To replace the battery, be sure to insert the |
|
battery into the remote control by matching the |
|
polarities (+ and |
|
• If the range or effectiveness of the remote control |
|
decreases, replace the battery. |
|
This product contains a CR Coin Cell Lithium Battery which contains Perchlorate
CAUTION
Danger of explosion if battery is incorrectly replaced.Replace only with the same or equivalent type. WARNINGS•Store the battery in a place where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately.
•Do not recharge, short, disassemble or heat the battery or dispose of it in a fire. Doing any of these things may cause the battery to give off heat, crack, or start a fire.
•Do not leave the battery with other metallic materials. Doing this may cause the battery to give off heat, crack, or start a fire.
This System is equipped with Virtual Dolby Surround. In Surround Mode, it creates a rich surround sound effect with two speakers.
To activate Surround Mode, press SURROUND MODE 1/2. Pressing the button beeps...
–Once when SURROUND MODE 1 is selected, or–Twice when SURROUND MODE 2 is selected.•SURROUND MODE 1: Creates a surround sound effect.•SURROUND MODE 2: Creates a richer surround sound effect than
SURROUND MODE 1.
–To cancel, press SURROUND OFF.Operating iPod device
•To select a track, press 4/¢.•For forward search/reverse search, press and hold 4/¢.•For Shuffle play, press SHUFFLE.•For Repeat play, press REPEAT.•To put iPod into sleep mode, press and hold iPod 6.iPod menu operation
1Press MENU to display the menu.
2Press UP or DOWN, then SELECT to select a menu
item.
Refer also to the instruction manual for the iPod for details.• To go back to the previous menu, press MENU.result from the use of this product. |
Troubleshooting
If you have a problem with this System, check this list for a possible solution before calling for service.
Power does not come on.=Plug in the power cord securely.No sound comes out of the speakers.=Adjust the volume level.=The sound has been turned off temporarily. Press FADE MUTING.
The remote control does not work.=Pull out the insulation sheet.=Replace the battery if exhausted.=Avoid sunlight shining directly on the remote sensor.=Do not block the path between the remote control and the remote sensor on the System.
=Point the remote control at the remote sensor on the System.=Move closer to the System.