Panasonic SDR-H90PC, SDR-H80PC Troubleshooting, Others, Problem, Check points

Others
			Troubleshooting
Helpful hints		2
	Problem			Check points
	This unit cannot be			≥ Charge the battery using the AC adaptor. (l 16)
	turned on.			≥ The battery protection circuit may have operated. Attach
	This unit does not stay			the battery to the AC adaptor for 5 to 10 seconds. If the unit
				still cannot be used, the battery is faulty.
	on long enough.			≥ Make sure the LCD monitor is opened.
	Battery runs down			≥ The battery is affected by ambient temperature. In cold
				places, the battery using time becomes shorter.
	quickly.			≥ The battery has a limited life. If the operating time is still too
				short even after the battery is fully charged, the battery has
				worn out and needs to be replaced.

This unit is turned off automatically.

≥If you do not use the unit for approximately 5 minutes, the power is automatically turned off to conserve battery life. To resume recording, turn the power back on.

The power will not turn off automatically when the economy function (l 27) is set to [OFF].

Remaining battery	≥ The remaining battery capacity indication is an
indication is not	approximation.
displayed properly.	If you think the remaining battery capacity indication is not
	displayed correctly, fully charge the battery, discharge it and
	then charge it again. (Even if this operation is performed, it
	may not be possible to display the remaining battery
	capacity correctly if the battery was used for a long period
	of time where the temperature was low or high or if the
	battery was repeatedly charged.)

This unit cannot be operated though it is turned on.

This unit does not operate normally.

≥The unit cannot be operated unless you open the LCD monitor.

≥Turn on the power again. If normal conditions are not restored yet, remove the battery or AC adaptor, wait about 1 minute and then reconnect the battery or AC adaptor. Then about 1 minute later, turn on the power again. (Conducting the above operation while the SD card or HDD is being accessed may damage the data on the SD card or HDD.)

101

LSQT1449