JVC XV-N680B, XV-N682S Installation and Setup, Setting up the Player, DVD Player Connections, and Setup, Operation, Reference, Introduction, Resolution setting, (S), (V), (A), (C)

Installation and Setup

Setting up the Player

The picture and sound of a nearby TV, VCR, or radio may be distorted during playback. If this occurs, position the player away from the TV, VCR, or radio, or turn off the unit after removing the disc.

DVD Player Connections

Depending on your TV and other equipment there are various ways you can connect the player. Please refer to the manuals of your TV, stereo system or other devices as necessary for additional connection information.

Rear of TV

Progressive Scan

•If your television is a high-definition or “digital ready” television, you may take advantage of the DVD player’s progressive scan output for the highest possible video resolution.

•Progressive scan does not work with the analog video connections (yellow VIDEO OUTPUT jack and S-VIDEO OUTPUT jack).

•The 1080p, 720p and 480p resolutions are the progressive scan applied resolution.

Resolution setting

1.Press RESOLUTION once. The current resolution setting will be appears in the display window.

2.Press RESOLUTION repeatedly to change the resolution you want.

The available resolution according to the connections are as shown below.

Introduction

and Setup

Rear ofDVD PlayerVideo and Audio Connections to Your TV

Make sure the DVD player is connected directly to the TV and not to a VCR, otherwise the DVD image could be distorted by the copy protection system.

S-Video – Connect the S-VIDEO OUTPUT jack on the DVD Player to the S-Video in jack on the TV using the S-Video cable (S).

Video – Connect the VIDEO OUTPUT jack on the DVD player to the video in jack on the TV using the video cable (V).

Audio – Connect the left and right AUDIO OUTPUT jacks of the DVD Player to the audio left and right IN jacks on the TV using the audio cables (A).

Do not connect the DVD Player’s AUDIO OUTPUT jack to the phone in jack (record deck) of your audio system.

Component Video – Connect the COMPONENT / PROGRESSIVE SCAN OUTPUT jacks on the DVD Player to the corresponding jacks on the TV using an Y PB PR cable (C).

OUTPUT CONNECTION	Available Resolution
	1920 x 1080p
HDMI	1920 x 1080i
	1280 x 720p
VIDEO OUTPUT
	720 x 480p
	720 x 480i
	1920 x 1080p
COMPONENT	1920 x 1080i
	1280 x 720p
VIDEO OUTPUT
	720 x 480p
	720 x 480i
VIDEO OUTPUT	720 x 480i
S-VIDEO OUTPUT	720 x 480i

Notes:

•VIDEO OUTPUT and S-VIDEO OUTPUT is always at 480i standard resolution.

•If your TV does not accept your resolution setting, abnormal picture appears on the screen.

Please read TV’s owner’s manual then set the resolution that your TV can accept.

•For 720p, 1080i and 1080p resolution on the component video out, only non-copy protected discs can be played back. If the disc is copy protected, it will be displayed at the 480p resolution without HDMI cable connection. With HDMI cable connection, the picture may not be displayed properly.

Installation

Operation

Reference

9