Getting started

To install batteries in the remote control unit

The battery compartment is located on the back of the remote control unit.

1Press down on the point shown by the arrow at the top of the compartment cover, and pull up the cover to open the compartment.

Getting started

2 Place the two accessory R6P (SUM-3)/AA(15F) batteries in the remote control according to the polarity markings (“+” and “–”) inside the compartment and on the batteries.

3Place the cover over the compartment, and press down lightly.

The batteries will last about six months with normal use. If the functions of the remote control become erratic, replace the batteries. See below for more information.

Precautions for the safe use of batteries

Observe the following precautions for the safe use of batteries. If they are used improperly their life will be shortened, they may burst or their contents may leak.

Precautions

Remove the batteries from the remote control if it is not going to be used for a long period of time.

Remove dead batteries and dispose of them properly.

Never leave dead batteries lying around, take them apart, mix them with other refuse, or throw them into an incinerator.

Never touch liquid that has leaked out of a battery.

Do not mix new and old batteries, or batteries of different types, when replacing them.

20

Page 22
Image 22
JVC XV-S300BK manual To install batteries in the remote control unit, Precautions for the safe use of batteries