12

Operating external components with the remote control

NOTE
Manufacturers’ codes are subject to change without notice.
Set the codes again after replacing the batteries of the remote control.
7To set the manufacturer’s code
You can operate a JVC TV without setting the manufacturer’s code.
1Slide the remote control mode selector

to TV.

2Press and hold TV.
Keep the button pressed until step 4 is finished.
3Press ENTER.
4Press number buttons (1-9, 0) to enter
the manufacturer’s code (2 digits).
Examples:
For a Hitachi TV:
Press 1, then 0.
For a Toshiba TV:
Press 0, then 8.
5Release TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
7Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
Set the remote control mode selector to TV.
The following buttons are available:
TV: Turns TV on and off.
TV VOL +/–: Adjusts the volume.
TV/VIDEO: Selects the input mode (either TV or
VIDEO).
CHANNEL +/–: Changes the channels.
1-10, 0, +10 (100+): Selects the channel.
TV RETURN: Alternates between the previously selected
channel and the current channel.
The buttons described below are used on pages 12 and
13.

Operating the TV

TV/VIDEO
REC
TV
VCR
VCR/DBS
DBS
VCR/DBS
TV
ENTER
TV RETURN
100+
VCR/DBS
VCR
DBS
Remote control
mode selector
Number
buttons
(play button)
Manufacturer Code Manufacturer Code
JVC 01 Samsung 12
Hitachi 10 Sharp 06
Magnavox 02 Sony 07
Mitsubishi 03 Toshiba 08
Panasonic 04, 11 Zenith 09
RCA 05
TH-S77[U].book Page 12 Wednesday, April 27, 2005 2:01 PM