Jwin JT-P670 Storing Phone Numbers in TWO-TOUCH Dial Memory Autodial, Conferencing, USE Indicator

5. Replace the receiver or press the SPEAKER button to end the procedure.

STORING PHONE NUMBERS IN TWO-TOUCH DIAL MEMORY (AUTODIAL)

You can store up to 10 phone numbers in two-touch memory. These numbers are assigned to any number key on the keypad. Reserve these buttons for numbers you use frequently.

1.Lift the receiver.

2.Press the STORE button.

3.Enter the phone number you want to store.

4.Press the STORE button again.

5.Press a number from 0 to 9 (to assign storage of the phone number). You can list these numbers in the index space provided on the console.

6.Hang up.

DIALING A NUMBER FROM ONE-TOUCH (M1/M2/M3) MEMORY

1.Get a dial tone (use either the receiver or speakerphone).

2.Press one of the 3 buttons. The stored phone number will dial automatically.

DIALING A NUMBER FROM AUTODIAL MEMORY

1.Get a dial tone (use either the receiver or speakerphone).

2.Press the AUTO button.

3.Press the numerical button to which the phone number is assigned. The unit will automatically dial the phone number stored in memory for the key you selected.

CONFERENCING

When you have two parties on two separate lines:

•Press the ‘CONF’ button and you can speak with both parties in a three-way conversation.

CANCELING THE CONFERENCE FUNCTION

•Press the ‘CONF’ button again to release the function.

IN USE INDICATOR

This LED will light when you lift the receiver-showing you that the phone is functioning. This will also serve to signal you if the receiver is off the hook or not properly seated in the base.

When there is an incoming call, the LED will flash until you lift the receiver.

6