QuickPan Rotator Base
Tripod threaded bushing adapter
The QuickPan III / IV Rotator Bases comes with a tripod adapter bushing which ac- commodates both 1/4 inch and 3/8 inch tripod mounts.
1/4 inch Tripod
If your tripod has a 1/4 inch threaded mount, leave the brass bushing in the center hole in the bottom of the rotator as shown at right.
3/8 inch Tripod
If your tripod has 3/8 inch threaded mount, remove the brass bushing by unscrewing it in a counterclockwise direction and screw- ing it into the adjacent hole in a clockwise direction using a coin (or large screwdriver) as shown at right.
Use the spare outer hole to store the brass bushing when you're using the 3/8 inch thread. That way, you won't lose the bushing!
Mounting camera bracket
To mount your camera bracket onto the rotator loosen the clamp lever at the bottom of the camera bracket.To loosen the clamp lever grab the lever and turn coun- terclockwise.The clamp lever is turned clockwise to tighten and counterclockwise to loosen.The lever part of the clamp lever is
Note:There are various images throughout this manual showing the mounting configurations of the cmarea brackets on the rotator.
slot