Standard Camera Bracket - Camera Mounting
Mounting your camera on the Standard Camera Bracket
To mount your camera, fi rst select the appropriate slot in the Vertical Camera Bracket that will best locate the tripod mounting thread on your camera.You may need to reposition the Captive Camera Knob.To remove the knob simply slide it along the slot to the end that has the threaded hole. Care- fully unscrew the knob out of the threaded hole, being careful not to crossthread the knob. Replace the knob into the appropriate slot by reversing the procedure.
Note: Always keep the offset portion of the Vertical Bracket towards the rear of the camera.
Next, install the knob into the ap- propriate slot then into the tripod mounting hole of your camera.
Turn the knob into the camera until it bottoms out, then turn the knob clockwise until the camera is tight on the Vertical Bracket. Don’t worry about getting the camera level at this time, as this is a task you’ll need to do when you’re ready to shoot.
Standard Camera Bracket on the QuickPan Rotator
The
The